Scribd
Upload
46 views1 page

ATC-3000 Quick Start

Uploaded by

kumarbinug
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views1 page

ATC-3000 Quick Start

Uploaded by

kumarbinug
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Off Power Off

Quick Start Guide PWR Red


On Power On
TCP/IP TO RS-232/422/485 CONVERTER
MODEL ATC-3000 4. Software Installation
■Insert the software CD and search for such as vcom.rar
Figure 2 ,and then open this file to setup the vcom software.
RS-232 Pinout：（DB9 Male） Note: Be sure you have administrative rights &disable fire-
（DB9Male） Signal I/O walls in windows XP.
PIN2 RXD IN
PIN3 TXD OUT
5. Configure the ATC-3000
IN5 GND - ■Use this section to set up your computer to assign it a static

1. Check Package Content RS-422/485 Pinout：（Six Terminal from left） IP address in the 192.168.0.1 to 192.168.0.254 range with a
Terminel No. 1 2 3 4 subnet mask of 255.255.255.0. This is necessary to ensure
■ATC-3000 unit 1Pcs
RS-422 T+ T- R+ R- that your computer can communicate with your ATC-3000.
■Printed version of this ATC-3000 Quick Start Guide
Your computer must have an Ethernet card and TCP/IP
1Pcs RS-485 485+ 485- - -
installed. TCP/IP should already be installed on computer
■Software CD 1Pcs ■Connect the power adapter to ATC-3000 and other apply
using Windows 98/2000/XP and later operating systems.
■Ext power adapter 1Pcs power. Power from other device.(+9--+24V@500-100mA).
■Open your web browser and type http://192.168.0.250 in

2. Hardware installation 3. LED indication the browser’s address box. This address is the factory default
IP Address of your ATC-3000. And then press “Enter”.
■Connect an Ethernet cable to ATC-3000 unit if connecting Name Color Status Description ■The “Username and Password required” message box
to a switch or cross-over direct to the PC as figure1 LINK Green Off Ethernet Disconnected will appear. Typing “admin” (default username) in the
Ethernet is connected in Username field and typing “admin” (default password) in the
Off 10M
SPEED Green Password field. Click “OK” The setup screen will then appear.
Ethernet is connected in
On
100M
You can turn to ATC-3000 TCPIP to serial User Manual.doc
System is not ready or
Off halt to get more information.

ACT Yellow
Figure 1 Data is transmitting
■ATC-3000 10/100 Port t connect to Ethernet card use Blink-ing between Ethernet and
RS-232/422/485
coss-Through Cable as figure2

You might also like