Scribd
Upload
6 views4 pages

Class Test 2

Uploaded by

Shrutii Agarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
6 views4 pages

Class Test 2

Uploaded by

Shrutii Agarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

ZEAL EDUCATION SOCIETY’S

ZEAL COLLEGE OF ENGINEERING AND RESEARCH


NARHE │PUNE -41 │ INDIA

Record No.: ZCOER-ACAD/R/16K Revision: 00 Date:01/04/2021

Class Test – II

Department: Civil Engineering Semester: I Academic Year: 2023 - 2024


Class: SE Date:
Course: Structural Analysis Maximum Marks: 70
Duration: 2.5 Hours
General Instructions (If any):

1) Answer Q.1 or Q.2, Q.3 or Q.4, Q.5 or Q.6, Q.7 or Q.8.


1) Figures to the right indicate full marks.
2) Assume suitable data, if necessary.
3) Use of electronic pocket calculator is allowed in the examination.
4) Use of cell phone is prohibited for searching answers.

Question No. Question Marks

Q.1 A Analyze the beam shown by slope deflection method and draw 12
BMD. Assume uniform flexural rigidity.

B Find the rotation B (θB) for the beam with uniform flexural rigidity 06
as shown in figure.

OR

Q.2 A Analyse the frame shown in figure 3 by slope deflection method 12


and draw BMD. Assume uniform flexural rigidity.
B Analyse the frame shown in figure 4 by slope deflection method. 06
Assume uniform flexural rigidity.

Q.3 A Analyze the continuous beam ABCD shown in figure 5 by 12


moment distribution method and draw BMD. Assume uniform
flexural rigidity

Define member stiffness; carry over moment and distribution factor 06

OR

Q.4 A Calculate final end moments for the frame shown in Fig. 6 by moment 12
distribution method and draw BMD

B Analyze bent ABC as shown in Fig. 7 by moment distribution method 6


Q.5 A Write note on stiffness method and write elements of displacement 6
matrix for following figure

B Analyse the continuous beam ABCD as shown in Fig. 9 by 11


stiffness method and draw bending moment diagram. Assume
uniform flexural rigidity.

OR

Q.6 A Explain degrees of freedom and stiffness 6

B Analyse the bent shown in Fig.10 by stiffness method and draw 11


bending moment diagram.

Q.7 A Define plastic hinge, load factor and shape factor. 6

B Calculate the collapse load Wu , for the beam shown in figure 11


OR

Q.8 A Explain different collapse mechanisms in plastic analysis with 6


diagram
B Determine shape factor for I section shown in figure 12 11

---------------- ALL THE BEST ----------------

You might also like