Scribd
Upload
23 views1 page

Basic Electronics Trainer

Uploaded by

development
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
23 views1 page

Basic Electronics Trainer

Uploaded by

development
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Basic Electronics Trainer

SPECIFICATIONS: 1. DC POWER SUPPLY (1) Fixed DC power supply: a. Voltage range: +/-5V，+/-12V b. Max.
Current output: 0.3A c. With output over-load protection (2) Dual DC power supply: a. Voltage range：+/-3V~ +/-18V,
continuously adjustable b. Max. Current output: 1A c. With output over-load protection 2. AC POWER SUPPLY a.
Voltage range: 9V~0V~9V b. Max. Current output: 500 m A c. With output over-load protection 3. SINGAL
GENERATOR (1) Pulse generator: (TTL level) a. Frequency range: 1Hz~10KHz / 4 settings, continuously adjustable
b. Fan out: 10 TTL load (2) Pulse switches: a. 2 independent output, TTL level b. With Q, Q output,pulse width > 5ms
c. Fan out: 10 TTL load (3) Data switches a. 8 sets independent control output,TTL level with De-bounce circuit. b.
Fan out: 10 TTL load 4. FUNCTION GENERATOR (1) Output waveform: Sine, triangle, square (2) Output frequency:
10~100KHz/4 settings, continuously adjustable (3) Output amplitude: 18Vpp (open circuit) 9Vpp (50 O load) 5.
TESTING AND DISPLAY (1) 3 1/2 digital voltmeter/ammeter a. DC voltage range: 2V，200V b. DC voltage accuracy:
+/-(0.3% of reading +1 digit) c. DC current range: 200 (2) Galvanometer a. Current range 50mA b. Accuracy Class
2.5 (3) LED indicator a. 10 sets independent LED indicates high, low logic state b. Input impedance: ≥100KΩ (4)
Digital display a. 2 sets independent 7-segment LED b. With BCD-7segment decoder/driver and DP Input c. Input
with 8-4-2-1 code Breadboard: 1680 tie-point breadboard on top panel can be easily put into and taken off
Accessories: Experiment manual, connection leads, connection plugs, breadboard List of Module: a. Basic Device
Module b. Basic Electricity Experiment Module c. Sensor Module(1) d. Sensor Module(2) e. Diode, Clipper and
Clamper Module f. Rectifier, Differentiator Integrator Circuit Module g. Transistor Amplifier Circuit Module h. Multi-
Stage Amplifier Circuit Module i. FET Circuit Experiment Module j. OP Amplifier Circuit Module 1, 2, 3, 4, 5 k.
Combination Logic Circuit Experiment Module 1, 2, 3, 4, 5 l. Sequential Logic Circuit Experiment Module 1, 2 m. Low
Voltage Electrical Control Module (3 is required) n. Single-Phase Motor Module (1 AC 220V) o. Three-Phase Motor
Module (3 220V) p. Load Unit Module q. System Transformer( Y Basic Electrical/Electronic Circuit Lab with all
Module and Complete teaching manual and advanced learning

You might also like