0% found this document useful (0 votes)
22 views1 page

How Do I Use The TEE in Dynamic Mode

Uploaded by

Nazmul Hasan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
22 views1 page

How Do I Use The TEE in Dynamic Mode

Uploaded by

Nazmul Hasan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

How do I use the TEE in Dynamic mode?

Products: Aspen HYSYS Dynamics


Last Updated: 06-Jun-2020
Versions: V10.0
Article ID: 000062206
Primary Subject:
Problem Statement
How do I use the TEE in Dynamic mode?

Solution
In Dynamic mode the flow rates of the exit streams from the TEE are determined by the pressure flow solver.
This gives the realistic flow behaviour in the dynamic simulation.
The user can also consider "Use Splits as Dynamic Flow Specs" in the TEE as shown below.

With this specification active, the user can define the flow of each stream by entering the valve openings for
each exit stream. This configuration is not generally recommended since the flow from the TEE is
determined from the split fractions and not from surrounding pressure network in the simulation. If this
option is used, the number of dynamic specification will increase by one. The user will need to remove one
specification, for example, the pressure-flow specification from one of the valves in the downstream of the
TEE.

There are two HYSYS cases attached for illustration purpose: one without the split specification and one with
TEE split specification.

Keywords
TEE, TEE Split Dynamics

You might also like