Scribd
Upload
185 views2 pages

ECE221

tt

Uploaded by

ankush02481
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
185 views2 pages

ECE221

tt

Uploaded by

ankush02481
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ECE221:ANALOG ELECTRONICS

L:3 T:0 P:0 Credits:3

Course Outcomes: Through this course students should be able to

CO1 :: understand the basic characteristics and operation of feedback amplifiers.

CO2 :: apply power amplifier design for the required specification.

CO3 :: develop oscillator designs for the given specifications.

CO4 :: examine circuit design for linear applications using op-amps.

CO5 :: design various circuits to generate signals for different applications using operational
amplifier.
CO6 :: develop circuits for different applications using op-amp as a comparator.

Unit I
Feedback amplifiers : Classification of amplifiers, The feedback concept, General characteristics of
negative feedback amplifiers, Effect of negative feedback upon output and input resistances, Voltage
series feedback, Current series feedback, Current shunt feedback, Voltage shunt feedback
Frequency Response of Amplifier : Distortion in amplifier, frequency response of an amplifier, low
frequency response of an RC coupled stage, high frequency response of an FET stage
Unit II
Power Amplifiers : Class A large signal amplifiers, second harmonic distortion, transformer coupled
audio power amplifier, efficiency, push-pull amplifiers, class B amplifiers, class AB amplifiers, reading
datasheet of 2N3055 power transistor
Unit III
Oscillators : Sinusoidal oscillators, Crystal oscillator, RC phase shift oscillator, wien bridge oscillator,
general form of oscillator circuit, hartley LC oscillators, collpit oscillator, reading datasheet of 1 MHz
crystal
Introduction to Operational amplifiers : The operational amplifier, block diagram of typical op-
amp, schematic symbol, characteristics of operational amplifier, reading datasheet of 741
Unit IV
Operational amplifier configuration : The ideal op-amp, equivalent circuit of an opamp, ideal
voltage transfer curve, open loop op-amp configurations, op-amp with negative feedback, block
diagram representation of feedback configurations, voltage series feedback amplifier, voltage shunt
feedback amplifier, differential amplifiers
Unit V
Operational amplifier applications I : Summing scaling and averaging amplifiers, instrumentation
amplifier, voltage to current converter with floating load, voltage to current converter with grounded
load, current to voltage converter, the integrator, the differentiator, introduction to active filters, first
order low pass Butterworth filter, first order high pass Butterworth filter, band pass filter, band reject
filter, all pass filter, square wave generator, triangular wave generator, sawtooth wave generator,
voltage controlled oscillator
Unit VI
Operational amplifier applications II : Introduction to comparators and converters, basic
comparator, zero crossing detector, schmitt trigger, voltage limiters, voltage to frequency and
frequency to voltage converters, analog to digital and digital to analog converters, sample and hold
circuit, The 555 timer, Phase locked loops, reading datasheet of 555

Text Books:
1. ELECTRONIC DEVICES AND CIRCUIT THEORY by ROBERT L. BOYLESTAD, PEARSON

References:
1. ELECTRONIC DEVICES & CIRCUITS by MILLMAN- HALKIAS, MCGRAW HILL EDUCATION

2. OP-AMPS AND LINEAR INTEGRATED CIRCUITS by RAMAKANT A.GAYAKWAD, PEARSON

Session 2024-25 Page:1/2


Session 2024-25 Page:2/2

You might also like