Subject: Signals & Systems
1. A) Determine whether the following systems are time invariant or not. [CO1][5M][BTL]
2
i. y ( t ) =t x (t)
2 x(t )
ii. y ( t ) =e
1. B) Define the following signals [CO1][5M][BTL]
i. Signum Function
ii. Sinc Function
2. A) Obtain trigonometric Fourier series for the waveform shown in the below figure. [CO2][5M]
[BTL]
2. B) Write the Dirichlet’s Conditions of Fourier Series. [CO2][5M][BTL]
3. State and prove the time convolution theorem for continues – time signals. [CO3][10M][BTL]
4. A) Define the following Continuous – time signals. [CO1][5M][BTL]
i. Real Exponential Signal
ii. Complex Exponential Signal
4. B) Determine the Power and Energy of the signal [CO1][5M][BTL]
x (t )= A sin (ω 0 t +∅ )
5. A) State and prove the Convolution Property of Fourier Transform [CO2][5M][BTL]
5. B) Find the Fourier Transform of the signal shown below [CO2][5M][BTL]
6. Find the convolution of the following signals [CO3][10M][BTL]
−2 t −4 t
i. x 1 ( t )=e u ( t ) , x 2 ( t )=e u(t)
ii. x 1 ( t )=cost u ( t ) , x 2 ( t )=u (t)
7. A) Define the following signals [CO1][5M][BTL]
i. Unit Step signal
ii. Unit Ramp Signal
iii. Unit Parabolic Signal
iv. Unit Impulse Signal
7 B) Sketch the following signals [CO1][5M][BTL]
i. 2 u ( t+2 ) −2u ( t−3 )
ii. u ( t+ 4 ) u(−t+ 4)
8. A) Find the Fourier transform of the signal x (t )=e−a|t| sgn(t) [CO2][5M][BTL]
8. B) Determine the Fourier Transform of the signal shown in the below figure. [CO2][5M][BTL]
9. Explain in detail about the Transfer function of an LTI system. [CO3][10M][BTL]
10. A) A rectangular function is given by
{
x (t )= 1 for 0< t< π
−1 for π < t<2 π}
Approximate the above function by a single sinusoidal sin t over the interval [ 0 , 2 π ] such that the
mean square error is Minimum. Evaluate the mean square error in this approximation.[CO1][5M]
[BTL]
10. B) Find the Even and Odd components of the following signal [CO1][5M][BTL]
j 2t
x (t )=e
11.A) Derive the expressions for Trigonometric Fourier Series coefficients. [CO2][5M][BTL]
11. B) Compute the Fourier transform for the signal x(t) shown in figure [CO2][5M][BTL]
12. State the following properties of LTI systems [CO3][10M][BTL]
i. The commutative property
ii. The distributive property
iii. The associative property
iv. Stability
