Scribd
Upload
23 views2 pages

Buck Boost

Good

Uploaded by

vickysharma36362
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
23 views2 pages

Buck Boost

Good

Uploaded by

vickysharma36362
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ASSIGNMENT 3

BUCK-BOOST CONVERTER

1. Determine D, ILmax, ILmin, Iin, ID, Isw, and ICrms for a buck-boost
converter Whose capacitor current waveform is shown in Fig. Assume L =
120 μH. (Power Electronics Circuit Analysis and Design Issa Batarseh &
Ahmad Harb)

2. Consider a buck-boost converter with the following specifications:

Vo = 12 V, Po = 25 W, Vin = 24 V, fs = 100 KHz.

(a) Design the above converter so it operates in the ccm.


(b) Find the maximum inductor current under both operating modes (c) If
the load changes by 50% (lighter load R increases), determine the new
mode of operation. (Power Electronics Circuit Analysis and Design Issa
Batarseh & Ahmad Harb)
3. Consider the following values for a buck-boost converter: Vin = 30 V, D =
0.25, R = 2 Ω, L = 330 μH, f = 10 KHz (a) Determine the mode of operation.
(b) Determine Vo.
(c) Determine C for a 1% output ripple.
(d) At what value of R does the transition between ccm and dcm occur?
(Power Electronics Circuit Analysis and Design Issa Batarseh & Ahmad
Harb)
4. Consider a buck-boost converter that supplies 100 W to Vo = 30 V from 50 -
30 V dc source. Let T = 100 μs and L = 800 μH.
(a) Determine the range of D for the given range of source voltage. (b)

Determine the average input current, diode current, IL max, and IL min

Under Vin = 35 .

(c) Determine the rms value of the diode current and the capacitor current.
Under Vin= 35V.
(d) Design for C so that the output ripple voltage is limited to 2% of Vo
Under. Vin =30V
(e) If the load resistor changed so that the converter load current is
Decreased by 10% what is the new duty cycle when Vin = 35V?
(Power Electronics Circuit Analysis and Design Issa Batarseh & Ahmad
Harb)
5. In a buck-boost converter, consider all components to be ideal. Let Vd be
840 V, Vo = 15 V (regulated), fs = 20 kHz, and C = 470 microF. Calculate
Lmin that will keep the converter operating In a continuous-conduction
mode if Po >= 2 W. (Power Electronics converter , application & design by
NED Mohan)

You might also like