Scribd
Upload
29 views14 pages

FEA-Lab Manual

Uploaded by

Jawad ahmed Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
29 views14 pages

FEA-Lab Manual

Uploaded by

Jawad ahmed Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 14

Lab Manual

Finite Element Analysis


(ME – 411)

NATIONAL UNIVERSITY OF SCIENCES &


TECHNOLOGY

PAKISTAN NAVY ENGINEERING COLLEGE

DEPARTMENT OF MECHANICAL ENGINEERING

FALL-2024

SUBMITTED BY :

REG. NO. :

SUBMITTED TO : SIR AFFAN AHMED


Lab 01
Objective :
 To simulate 25x75 rectangle static structurally

 add material in engineering data, define properties e.g. Young’s modulus,


Poisson’s ratio

 Draw a rectangle of 25x75 and excrude it up to 1m


 Insert fixed support and select the bottom side to fixed it also insert force of
3000N on upper side.

 Insert equivalent stress(von Mises)


Lab 02
Objective :
 To simulate and compare the results of I beam of two different materials i.e.
steel and concrete
 Add steel and concrete materials in engineering data

 Open design modeler, select cross section under concept tab and add I beam
geometry

 excrude I beam geometry.


 Fixed front face and apply force in downward direction of 2000 N on top
face of I beam

 equivalent stress and total deformation of steel and concrete

Concrete
(Total deformation) :
Steel

(Total deformation) :
Lab 03
Objective :
 To compare Equivalent von-mises stress generated in T shape
geometry with and without sharp edges

 Add structural steel in engineering data

 Add T section under concept tab

 Excrude geometry
 fixed front and back face of T shape structure and apply pressure

 Equivalent von-Mises stress


 Again , go to geometry ,select fixed radius under blend tab and select all the
sharp edges in geometry to make them blend of radius 0.001m. Also generate
mesh.

 Equivalent von-Mises stress and varying pressure magnitude.

 Table :
Pressure Equivalent Von-Mises Equivalent Von-Mises
stress (sharp edges) Pa stress (Without sharp
edges) Pa
1000 3.9569e5 1.3203e6
2000 7.8128e5 2.3805e6
3000 1.3768e6 3.7608e6
4000 1.8694e6 4.8211e6
5000 1.923e6 5.9014e6

 Graphs :
Lab 04
Objective :
 select structural steel

 go to create tab ,select primitives and then box


 fixed the bottom face of box and apply remote force

 Equivalent Von-Mises stress and convergence under that stress.

You might also like