Anybus X-gateway - EtherNet/IP™ Scanner Interface Network Installation Sheet

Product Overview LED Indicators IP Address Configuration Switches

The EtherNet/IP Scanner interface can only be mounted in the top slot LED Indication Meaning Sets the binary value of the last byte of the IP address within subnet
of the Anybus X-gateway. GW Status See Gateway Installation Sheet 192.168.0.1–254 (netmask 255.255.255.0). To use a different subnet,
LA Green Link established
set all switches to OFF and configure with Anybus IPconfig.
Top view Green (flashing) Receiving/transmitting data 128 64 32 16 8 4 2 1 Binary value
Off Link not detected OFF OFF OFF OFF OFF OFF OFF OFF IP address set with IPconfig
IP Address Configuration Switches OFF OFF OFF OFF OFF OFF OFF ON 192.168.0.1
MS Green Normal operation
OFF OFF OFF OFF OFF OFF ON OFF 192.168.0.2
EtherNet/IP Connector (X1) Power Connector (X3) Green (flashing) Standby, not yet configured
Red Major fault, unrecoverable ON ON ON ON ON ON ON OFF 192.168.0.254
ON ON ON ON ON ON ON ON (Not valid)
Red (flashing) Minor fault, recoverable
1 2 3 4 5 6 7 8 Switch number
1 2 3 4 5 6 7 8 Red/green (alternating) Hardware self test
ON
Off No power
NS Green EtherNet/IP connection(s) OK = 192.168.0.1
1 2 3 4 5 6 7 8
Green (flashing) No EtherNet/IP connections ON
Red Duplicate IP address
Red (flashing) Connection timeout
Red/green (alternating) Hardware self test
Accessories Checklist
Off No power or no IP address set The following items are required for installation:
Front view
• EtherNet/IP configuration tool (optional, not included)
• USB cable (included)
• EDS file for EtherNet/IP (see www.anybus.com)
• LAN cable (not included)

Installation and Startup Summary

(Depending on your setup, some steps may not be required.)
1. Connect the gateway to the EtherNet/IP network
GW Status 2. Set a valid IP address for the EtherNet/IP interface
LA (contact your network administrator for information)
MS Status LED:s 3. Connect a PC to the gateway via USB
NS
4. Power up and configure the gateway
5. Install the EDS file in the EtherNet/IP configuration tool
EtherNet/IP (RJ45) Connector
Technical Support
Pin Signal
Technical support, documentation and software downloads are
1 TD+ available at www.anybus.com.
2 TD- Technical questions regarding the EtherNet/IP fieldbus system should
3 RD+ be addressed to ODVA at www.odva.org.
USB Connector (X4) 1 8 4, 5, 7, 8 Termination to PE
6 RD-

ODVA™ and EtherNet/IP™ are trademarks of ODVA, Inc.

SP1763, rev. 2.20, Sep 2016 www.anybus.com