We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 3
TTIAR GOVERNMENT COLLEGE OF ENGINEERING
& TECHNOLOGY,
KARAIKUDI- 630 003
ALAGAPPA CHE}
Department of Electrical and Electronics Engineering
V Semester(B Section)
Internal Assessment Test -1 I
19EEC62— POWER ELECTRONICS.
‘Question Paper
Date: 02.09.2024
Maximum Marks : 50.
9]
juration: 90min’
‘Answer ALL the Questions
Part—A (92=18 Marks)
T-] Define latching current and holding current in SCR.
| List the tun on methods of SCR?
ist the power line disturbances caused by switching power converts
| What is the function of pulse transformer in a firing circut?
| What is meant by natural commutation?”
Explain the principle of dual converter
‘Why is the power factor of semi converter is better than full converter?
| Whats the function of freewheeling diodes in a controlled rectifier?
‘What is meant by line commutated inverter?
Part—B x16 =32 Marks
Diaw the (wortransistor analogy of a SCR? Explain SCR operation [U [8
with this analogy.
SSS
iejel[efe]ec]
ele
Shs
‘Summarize the various types of commutation circuits for SCR u [8
Or) [=
|. | Explain the switching characteristics of MOSFET. ‘with neat diagrams. U 8
8
‘Summarise the design procedure of the snubber circuit for SCR which | U
is used a switching device in AC to DC conversion circuit,
Derive the expressions for average output voltage and rms output | Apy | 6
voltage of I dp semiconverter.
“Analyse the working of 3 @ fully controlled phase controlled ‘converter | Apy | 10
for R laod and derive the expressions for average output voltage
(Or)
“Analyze the effect of source inductance in the operation ofasingle | Apy | 10
nase fully controlled converter with relevant diagram and analysis.
Derive the output continuous current expressions ofa single phase fully | Apy | 6
controlled converter with RL load amen |——————“ALAGAFPACHIETTIAN ‘
GOVERNMENT COLLEGE OF ENGINEERING & TECHNOLOGY
a £ KARAIKUDI- 630 003
i Department of Electrical and Electronics Engineering
V Semester(B Section)
Tnternal Assessment Test -1T seas pars
22EECS2 ~ POWER ELECTRONICS
‘Question Paper
‘Duration: 90min | Date: 16102024
Maximum Marks «0
“Answer ALL the Questions Soil :
2 Part—A (2 2=18 Marks)
COI |__| List anytwo switching device considerations in DC-DC Cor Understand | 2
COs [2 _| What is TRC is Understand | 2
COs | 3__| What is meant by cu control? z | Understand | 2
COS | 4. | List any four applications of DC-DC Converters Understand | 2
COS | __5._| Define modulation index. [Understand | 2
‘COs 6__| Whatare the agvantages of PWM inverters? eon." [Understand | 2
COT | _7._| Whatare the purposes of feedback diodes in inverters? | Understand [2
COS_[_#_| What is UPS? [Understand [ 2
coz | List the methods of voltage control in inverters? —_ | Understand | 2
Part=B Qx16= 32 Marko)
CO2 | 10a. | With necessary equations and waveforms analyze the operation of a self | Analyse | 10
‘commutated step down chopper with RL load.
COS | 10b:” | Buck do-de COhverter with Low Pass Filter has the following | Apply [6
parameters; Vs=S0V, L=400H C=100HF f20kHz R=202 D=04
‘Assuming ideal components, calculate (a) the output voltage Vo, (b) the |
soaximum and minimum indtor ent and (c) the ouput volage Hep l
Or)
COS | Ma | Withnecessary volt-sec equations and waveforms analyze operation of Type | Analyse | 1
B chopper.
PCOS | lb. | A de-do buck converter has an input voltage of 400 V and a load resisior Apply | 6
402. The switching frequency of the converter is 2kHz and the converter
switch voltage drop is 2V. When the switch is conducting at duty cycle 0.5,
_ | Determine the value of chopper efficiency.
C02 | 12a | Explain the operation of single phase auto sequential commutated current | Understand | 8
source inverter with equivalent circuits in different modes of operation. |
CO4 | 126, | Explain sinusoidal pulse width modulation technique in single phase voltage | Understand | 8
source inverter. i
(Or) z
COD | 13. | With neat circuit diagrams, waveforms and equations, explain the operation | Understand | 1
of'a three-phase voltage source inverter in 180 degree conduction mode. __| Z~~ ALAGAPPA G1
a ‘ :
=— GOVERNMENT COLLEGE OF ENGINEERING & TECHNOLOGY
a KARAIKUDI- 630 003 ein
~~ Department ‘of Electrical and Electronics Engineering
‘Vv Semester(B Section)
Internal Assessment Test 1M
2EECS2 - POWER ELECTRONICS 4
x Question Paper
Duration: Sorin “Rnswer ALL the Questions Date 27.11, 2024
Maximum Marks = 50
Bart—A (9X2=18 Marks) ee
COS | 1. | List any four applications of ac voltage controllers. ~[Uadersiand | 2
or | 2] Whatis the difference between ON-OFF control and phase control? Understand | 2 |
Oz |3~| What is the effect of source and load inductance in AC voltage controllers Understand | 2
GOT] 4] Draw the circuit diagram of Bi-directional AC voltage controller with star Understand | 2
connected resistive ious. al =
COD |S. | What do you mean by synchronous tap changer related to ‘AC voltage Understane | 2
controllers
CO2 | 6. | What do you mean by multistage sequence control in "AC voltage contollers Understand | 2
COs | 7. | List anye four applications of cyclo-converter? Understand | 2 |
COD | 8. | List out the advantages and disadvantages of cyclo ‘converters? Understand | 2 |
Ci 1-9} Draw the schematic of harmonic filter in AC voltage controllers Understand | 2
a 70 With-a neat circuit diagram, analyse the operation OF single phase | Analyse asi
bidirectional AC voltage controller with RL load.
(@n)
COs ] Tia |A single phase ON-OFF type ac voltage Controller with an input of] Analyse e
230V,50Hz is connected to a resistive laid of 200. The circuit is
operating with the switch ON for 30 cycles and OFF for 30 cycles.
Determine i)the RMS current ii) the input power factor.
GOs} 1b TA single phase full wave ac voltage controller has a resistive Toad of | Analyse |&
R100 and the input voltage is Vs =120V, 60Hz. The delay angles of
thyristors T; and T2 are eqaul; ay=a2=;. i) Derive the expression for
RMS output voltageV. ii) input power factor
Gor] Tz Describe the operating principle of single-phase to single-phase step Understand | 16
up cycloconverter with the help of mid-point and bridge type
configuration. Illustrate the answer with appropriate circuit and
waveforms
On
Zor} is Describe the operating principle of single-phase to single-phase step- Understand | 16
down cycloconverter with R and RL loads.