0% found this document useful (0 votes)
52 views2 pages

Model 310B Data Sheet EN

Uploaded by

BSM
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
52 views2 pages

Model 310B Data Sheet EN

Uploaded by

BSM
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MODEL 310B

LONG RANGE MICROWAVE LINK

K-BAND PERFORMANCE WITH NARROW BEAM WIDTH FOR LONG RANGE OR


NARROW-CORRIDOR APPLICATIONS
Because Model 310B operates at K-band frequency (24.125 GHz), it
KEY FEATURES
achieves performance not possible with ordinary X-band microwave links
(which operate at 10.5 GHz). Antenna beam-width is approximately 3.5
degrees in both the horizontal and vertical planes. This means that mod- DETECTION TO 457 M (1500 FT)
el 310B will operate at very long ranges and within very narrow corridors. RESISTANT TO RADAR INTERFERENCE

Each Model 310B Transmitter and Receiver are packaged in weather- NARROW BEAM, LOW SIDELOBE ANTENNAS
proof housings which are only 269 mm (10.6 in) in diameter and weigh
only 2.0 kg (4.5 lbs). Comparable X-band systems require housings  IDE DYNAMIC RANGE PHASE LOCKED LOOP
W
(PLL) SIGNAL PROCESSING
which are 609 mm (24 in) in diameter and weigh 15.9 kg (35 lbs). This
small size provides optimum resistance to wind-loading and obvious ad- K-BAND MULTIPATH DETECTION
vantages for installation and shipping.
 ELF-CONTAINED ALIGNMENT CIRCUITS AND
S
Because its K-band microwave frequency is 2.5 times higher than the LED TROUBLESHOOTING INDICATORS
X-band, the multipath signal generated by an intruder is also 2.5 times
 AN BE OPERATED IN VERTICAL (E) OR
C
higher and detection of slow-moving intruders is correspondingly bet-
HORIZONTAL (H) POLARIZATION
ter. With its superb beam control and higher multipath frequency, Model
310B provides unmatched detection performance.

Phase Locked Loop (PLL) signal processing in the receiver increases de-
tection probability by alarming on partial or complete beam interruption,
increase or decrease in signal level or jamming by other transmitters. Its
Automatic Gain Control (AGC) circuit permits the receiver to compensate
for varying site conditions or changes in the weather.

Operating at K-band, which is much less crowded than X-band, Model 310B is inherently less susceptible to outside interference
from airport landing systems, aircraft or marine radar, and other microwave intrusion systems. Four field-selectable modulation
channels with narrow band PLL filters allow several Model 310B’s to be used together without mutual interference. Model 310B
can also be stacked with an X-band link, such as the Southwest Microwave Model 300B, with no danger of mutual interference.
Such an arrangement provides the ultimate in detection performance and extremely high resistance to electronic jamming.
MODEL 310B SPECIFICATIONS
OPERATION SPECIFICATIONS

Intrusion detection, using a modulated amplitude sensitive Equipment Supplied: Model 310BT Transmitter, Model 310BR
system (not doppler), takes place within the invisible pattern Receiver, Universal swivel ball mounting brackets.
of microwave energy existing between transmitter and receiver.
Changes in signal amplitude at the receiver are directly Frequency: 24.125 GHz (USA) conforms to F.C.C. Part 15.
related to the object’s size and density, allowing the sensor F.C.C. Identifier CA68H9310B.
to discriminate between objects. Model 310B will alarm on
average sized humans walking, running or crawling on hands Output Power: 4mW peak, 2mW average, square wave
and knees through the pattern. Field adjustments can provide modulated.
alarm on larger or smaller targets, depending on the specific
application. Range: 30.5 m to 457 m (100 to 1500 ft)

The solid state electronics and antenna of Model 310B are Target Size: 35 kg (77 lbs) human walking, running, hands
mounted on a rugged metal baseplate and covered by a molded and knees crawling or jumping. Prone crawling or rolling 35
ABS radome. Swivel mount permits precise setup and provides kg (77 lbs) human, or simulated with a 30 cm diameter metal
firm lock against movement. sphere detected at maximum range of 183 m (600 ft).

For detailed information on application, installation and Target Velocity: 30 mm/sec to 15 m/sec (0.1 ft/sec to 50
adjustment, consult the Model 310B Technical Manual. ft/sec).

Probability of Detection: 0.99 minimum.


DIMENSIONS
Automatic Range Adjustment: Link automatically adjusts to
MOUNTING HOLES slow changes in path loss due to rain, snow, etc. AGC range
114 mm (4.5 in)
102 mm (4.0 in)
102 mm (4 in) U-bolt standard -54 dB.
(Post should be 102 mm (4 in) O.D.)
71 mm (2.81 in)
Modulation Channels: Four, field selectable.

270 mm False Alarm Rate: 1/unit/year based on signal to noise ratio.


(10.6 in)
DIA. 20° MAX TILT
89 mm (3.5 in) ANY DIRECTION Operating Environment: -40°C to +66°C (-40°F to +150°F)
0-100% Relative Humidity.
257 mm
152 mm (6.0 in) (10.125 in) DC Input: 11 VDC to 14 VDC at 150 mA (Tx), 20 mA (Rx).

Alarm Output: SPDT-Form C, 2 amps at 28 VDC.


PATTERN
Tamper Switch: SPDT-Form C, 2 amps at 28 VDC.
The detection pattern width is field adjustable from
Self Supervision: Alarm on failure and remote test.
approximately 0.6 to 12.2 m (2 to 40 ft). Pattern height varies
in conjunction with pattern width. The pattern width adjustment
Mounting: Locking ball swivel mount. 20° adjustment in any
allows easy adaptation to the final installation site.
direction.

Remote Monitor: Alignment, sensitivity and power supply


voltage monitored with RM83 Performance Test Set at
receiver.

LED Indicators: Internally located LED’s - power on at


Pattern Width Ajustable from 0.6 – 12.2 m (2 – 40 ft) transmitter. Alarm, jamming signal and wrong channel at
receiver.

Weight: 2.04 kg (4.5 lbs) each unit.

Shipping Weight: 8.2 kg (18 lbs) total.

Specifications subject to change without notice.

USA (CORPORATE HEADQUARTERS): EUROPEAN OFFICES: MIDDLE EAST OFFICES:


Southwest Microwave, Inc., Arizona, USA Southwest Microwave Ltd., Worcestershire, UK Southwest Microwave, Inc., Dubai, UAE
Telephone +1 (480) 783-0201 Telephone +44 1386 75 15 11 Telephone: +971 4 371 2624

Rev: 6/2015 | ©2015 Southwest Microwave, Inc. All rights reserved. www.southwestmicrowave.com

You might also like