Scribd
Upload
6 views8 pages

Module 10

Uploaded by

Abdelhamid Benallel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
6 views8 pages

Module 10

Uploaded by

Abdelhamid Benallel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

Module-10

1. Detailing all identified risks, including descriptions, category, and probability of


occurring, impact, responses, contingency plans, owners and current status is called

Management reserves

Change control

Contingency reserves

Risk register
Correct Answer : d Explanation : A risk register is a tool in risk
management and project management. It is used to identify potential risks in a
project or an organization, sometimes to fulfill regulatory compliance but mostly to
stay on top of potential issues that can derail intended outcomes.

2. Change management systems are designed to accomplish all of the following


except

Track all changes that are to be implemented

Review, evaluates, and approve/disapprove proposed changes formally

Identify expected effects of proposed changes on schedule and budget

All of the Above


Correct Answer : d

3. Potential difference between the two points is called

voltage

current

resistance

power
Correct Answer : a Explanation : Potential difference between the two points is
called voltage or potential

4. Two resistors are connected in parallel. Find the total resistance value

R1 + R2
R1 - R2

R1R2 / R1+R2

R1R2
Correct Answer : c Explanation : 1/ RT =(1/R1)+(1/R2)

5. A device which convert DC to AC is called

inverter

Rectifier

Chopper

Cycloconverter
Correct Answer : a Explanation : inverter can be used to
convert DC to AC

6. Synchronous motor always runs at

the synchronous speed

less than synchronous speed

more than synchronous speed

none of the above


Correct Answer : a Explanation : Synchronous motor always runs at
the synchronous speed

7. Induction motor is also called as

static machine

rotating transformer

constant speed

special machine
Correct Answer : b Explanation : Its work on transformer
principle,that’s why it is also called as rotating transformer
8. The back e.m.f. of a synchronous motor depends on

Speed

load

excitation given by field winding

all of the above


Correct Answer : c Explanation : Similarly, in
a synchronous machine, a back e.m.f. Eb is set up in the armature (stator) by the
rotor flux which opposes the applied voltage V. This back e.m.f. depends on rotor
excitation only

9. On which of the following factors skin effect depends

Frequency of the current

Size of the conductor

Resistivity of the conductor material

All of the above


Correct Answer : d Explanation : Factors affecting skin effect:
Frequency, Diameter, The shape of the conductor, Type of material.

10. The effect of corona can be detected by

presence of ozone detected by odour

hissing sound

faint luminous glow of bluish colour

all of the above


Correct Answer : d Explanation : The corona effect can also
produce a violet glow, production of ozone gas around the conductor, radio
interference, and electrical power loss.

11. For transmission of power over a distance of 500 km, the transmission voltage
should be in the range

150 to 220 kV
100 to 120 kV

60 to 100 kV

20 to 50 kV
Correct Answer : a Explanation : The highest the distance, the voltage
level should be high.

12. In the analysis of which of the following lines shunt capacitance is neglected

Short transmission lines

Medium transmission lines

Long transmission lines

Medium as well as long transmission lines


Correct Answer : a Explanation : In Short transmission lines, the shunt
capacitance is neglected

13. Assume that the op-amp of the fig. is ideal. If Vi is a triangular wave, then V0
will be

Square wave

Triangular wave

Parabolic wave

Sine wave
Correct Answer : d Explanation : If Vi is a triangular wave, then V0
will be sine wave

14. A differential amplifier is invariably used in the i/p stage of all op-amps. This is
done basically to provide the op-amps with a very high

CMMR

Bandwidth

Slew rate
Open-loop gain Correct
Answer : c
Explanation : The slew rate of an op amp or any amplifier circuit is the rate of
change in the output voltage caused by a step change on the input. It is measured
as a voltage change in a given time
15. A differential amplifier has a differential gain of 20,000. CMMR=80dB. The
common mode gain is given by

0.5 0
Correct Answer : a

Explanation :

16. Which of the following amplifier is used in a digital to analog converter

Non inverter

Voltage follower

Summer

Difference amplifier
Correct Answer : c Explanation : Since digital to analog
conversion is simply a weighted sum of the binary input, a circuit called a summing
amplifier is used.
17. The best indication about the state of charge on a lead-acid battery is given by

output voltage

temperature of electrolyte

specific gravity of electrolyte

none of the above


Correct Answer : c Explanation : the state of charge on a
lead-acid battery is determined by specific gravity of electrolyte

18. The output voltage of a charger is.

less than the battery voltage

higher than the battery voltage

the same as the battery voltage

none of the above


Correct Answer : b Explanation : The output voltage of a charger is always higher
than the battery voltage

19. Five 2 V cells are connected in parallel the output voltage is

1V

1.5 V

1.75 V

2V
Correct Answer : d Explanation : When cells are connected in
parallel the total value of the cells is the same as each individual cell.

20. The ground wire should not be smaller than No ______ copper

6
10
Correct Answer : d Explanation : Ground wire should not be smaller
than 10mm thickness.

21. Resistance grounding is used for voltage between:

33kVto66kV

11kVto33kV

2.2kV and 33kV

none of the above


Correct Answer : c Explanation : This type of resistance earthing is commonly
employed for the system operating at voltages between 2.2 kV and 33 kV and the
power source capacity exceeds 5,000 kVA.

22. In Railway applications ______ circuit breaker is used.

SF6

bulk oil

minimum oil

air break
Correct Answer : d Explanation : Air blast Circuit breaker is used in
Railway electrification.

23. In open loop system

the control action depends on the size of the system

the control action depends on system variables

the control action depends on the input signal

the control action is independent of the input signal


Correct Answer : d
Explanation : Then an Open-loop system, also referred to as non-feedback system,
is a type of continuous control system in which the output has no influence or effect
on the control action of the input signal. In other words, in an open-loop control
system the output is neither measured nor “fed back” for comparison with the
input.

24. The function of breather in a transformer is

increase power

to cool the coils during reduced load

to cool the transformer oil

to arrest flow of moisture when outside air enters the transformer


Correct Answer : d Explanation : The function of breather in a transformer is
to arrest flow of moisture when outside air enters the transformer.

25. Part of a project is to Develop Product Specifications. This is best classified as an

Event

Path

Activity

Node Correct Answer : c Explanation : An activity is


typically one stage of a project management plan. Each activity consists of one or
more actions that, upon completion, will lead to the next project stage. Taken
together as a series, the activities will result in the final deliverable.

You might also like