Scribd
Upload
10 views2 pages

C H3003 Pages: 2: Answer All Questions, Each Carries 4 Marks. Answer All Questions, Each Carries 4 Marks

Uploaded by

Afreen Mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views2 pages

C H3003 Pages: 2: Answer All Questions, Each Carries 4 Marks. Answer All Questions, Each Carries 4 Marks

Uploaded by

Afreen Mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

C H3003 Pages: 2

Reg No.:_______________ Name:__________________________


APJ ABDUL KALAM TECHNOLOGICAL UNIVERSITY
THIRD SEMESTER B.ARCH DEGREE EXAMINATION, DECEMBER 2018
Course Code: ES201
Course Name: THEORY OF STRUCTURES III
Max. Marks: 60 Duration: 3 Hours
PART A
Answer all questions, each carries 4 marks. Marks
1 List any four assumptions
ssumptions in torsion equation (4)
2 Draw Eulers curve. Mention the limitation
l of Euler’s formula. (4)
3 Define Degree of Static Indeterminacy with 2 example (4)
4 How can we use theorem of three moment when external support fixed (4)
5 Define Stiffness factor and Distribution Factor with figures (4)
PART B
Answer any two questions, each carries 10 marks.
6 Power of 2100KW has to be transmitted
transmi at 1Hz. If the permissible shear (10)
stress is 80N/mm2, determine the diameter for a solid shaft of circular
cross section. If a hollow circular section is used with its internal
diameter is 0.7 times the external diameter, calculate the saving in mass
per meter
ter length of the shaft.
7 A simply supported beam of length 4m is subjected to a uniformly (10)
distributed load of 30 kN/m acting through whole span and deflects
15mm at centre. Determine the crippling load when this beam is used as a
column with both
oth ends hinged. Also determine the safe load if the factor
of safety is 3.
8 Analyse the propped cantilever using consistent deformation method and (10)
draw Shear force diagram &bending moment diagram.Assume
.Assume I uniform

Page 1 of 2
C H3003 Pages: 2

PART C
Answer any two questions, each carries 10 marks.
9 Analyse the continuous beam using three moment theorem and draw (10)
Shear force diagram and Bending moment diagram.Assume
diagram.Assume uniform
section.

10 Analyse the continuous beam using slope deflection method and draw (10)
Shear force diagram &bending moment diagram.Assume
.Assume uniform
section.

11 Analyse the frame using moment distribution method and draw Bending (10)
moment diagram.Assume
.Assume moment of inertia I for BC.

****

Page 2 of 2

You might also like