Coolspool-29

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

coolspool 29 28V aircraft start unit

The Coolspool 29 is available in two nominal output voltages,


26V DC or 28V DC. This aircraft start unit is used extensively on
larger twin turbine aircraft and helicopters where additional
amp/hour capacity is required to maintain voltage under load.
Upper Fadec limits vary according to the manufacturer’s
software and for this reason two versions of the Coolspool 29
are available.
When compared to a 24V DC start unit of the same capacity,
the Coolspool 29 delivers a significantly higher performance,
resulting in faster spool-ups and cooler starts impacting directly
on turbine life.
This aircraft start unit is designed to be carried on board for
emergency power or turbine starting and is fitted with an
automatic 3-stage internal charger for maximum cell longevity.
The Coolspool 29 is fitted with solid state voltmeter with ‘push
to view’ button to monitor battery voltage.
A spring-loaded output cover ensures the aircraft start unit is
cleared for air transportation. Supplied with Nato lead set,
charge lead and heavy-duty canvas protective jacket.

Supplied as standard with

Country-specific Padded
input cord 2m Nato lead protective jacket

Typical power plant:*


Williams FJ-33, PT6-67, Arrius, or power plants of a similar specification

Corporate jets 10-16-seat helicopters with shaft turbines

*This information is given in good faith


coolspool 29
Specifications
Peak amps**
Nominal voltage
2400A
26V or 28V DC depending on model
Features
l High powered sealed lead acid AGM batteries
Standing voltage 27.8V DC or 30V DC depending on model l Cleared for air transportation
Amp/hour capacity 26 Ah @ 10 hr rate (20°C) l Internal charger with LED status indicator
Operating temp -40°C to +45°C (-22°F to + 113°F) l Corrosion resistant aluminium case with carry handle
Case Aluminium with shock absorbing feet l Controls protected by twin front protection bars
Voltmeter Solid state LED, IP65 l Aircraft cable with heavy-duty Nato connector
Aircraft cable 2m (6ft) with heavy-duty rubber Nato connector l Spring-loaded output connector cover
Charger 1.9A 3-stage internal charger/ l Auxiliary socket for plug-in accessories
90–264V AC/47–63Hz/single phase
l Solid state voltmeter with ‘push to view’ feature
Dimensions H 345mm (13in), L 405mm (16in), W 135mm (5in)
l Fitted with rubber anti-slip, shock absorbent feet
Weight 26V DC: 28kg (61lb)
l Heavy-duty canvas protective jacket
28V DC: 29kg (63lb)
NCAGE KD628
Optional extras
** Peak amps is a theoretical calculation of the instantaneous current from a momentary dead short
across the battery terminals. It is not representative of the power delivered at the aircraft plug
due to cable losses and other factors. This figure is only shown for comparative purposes.

Universal single trolley 4m Nato lead 24V inspection lamp

Other GPUs and power supplies in the Powervamp range

Coolspool 17 (26V) Coolspool 29 Twin GPU 1500/40 PS100 PS300 GPU 2400
(26V)

Powervamp Ltd 22 Bridgwater Court, Oldmixon Crescent, Weston-super-Mare, BS24 9AY, England
Tel: +44 (0)1934 643000 Fax: +44 (0)1934 642800 Email: [email protected] www.powervamp.com

© Powervamp Ltd. Measurements, weights, technical performance and other specification data are
typical and may vary. Powervamp reserves the right to alter or amend specifications without notice
as part of its program of continuous improvement. Powervamp is a trademark of Powervamp Ltd.

6170

You might also like