Scribd
Upload
15 views1 page

Adobe Scan May 11, 2024

Uploaded by

pramodsrma2220
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
15 views1 page

Adobe Scan May 11, 2024

Uploaded by

pramodsrma2220
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

USN

JSS MAHAVIDYAPEETHA
JSS SCIENCE AND TECHNOLOGY UNIVERSITY, MYSURU
Department of Mechanical Engineering
ISemester: Test-I
Engineering Graphics and Design (22ME120)
Duration: 1.25 Hours Date: 09/12/2023 Section:D Max. Marks:30
NOTE: Answer the following Questions.

Q.NO CO BL PI QUESTION MARKS


|Iwo points R and S are on HP. The point R is 35mm in front
1 of VP, while S is 50mm behind VP. The line joining their top
Application 1.4.1 Views makes an angle of 40 with XY. Find the horizontal 05
COI
distance between the two projectors.
A line has its endA 15mm above HP and 10mm in
front of VP. The
end B is 55mm above HP and the line is inclined at 30 to HP. The
2.
distance between the end projectors is 50mm. Draw the
1.4.1 the line and detemine the true length of the line and itsprojections of
10
CO1 Application
with VP. inclinations
A hexagonal lamina of sides 25mm
rests on one of its cormers
3 on HP. The lamina makes 45° to HP and the
CO2 diagonal pass1ng
Application1.4.I through the cormer on which it rests is inclined at 30° to VP.
15

Draw its projections.


OR
Draw the projections of a circular plate of negligible thickness
of S0mm diameter resting on HP on a point A 15
Application 1.4.1 circumference, with its on the
4. CO2 plane inclined at 4s°to HP and the
diameter passing through the resting point appears to be
inclined at 60° to VP.

Course Outcome: At the end of the course the students will have the ability to

CO-I Apply the knowlcdyc of using CAD sottwarc ctlectivcly. Apply and intepret thc conccpt of
distanccs
objects from reference planes, Tnue length (TL), True inclinations (TI), Apparent Length (AL), of
Anparent
Inclinations (Al) and create 2D drawing.
CO-2 Apply and interpret the concept of Truc shupe (TS) of two dimensional objects (Plane Surfaces).

PI's

I.4.1 Apply Mechanical Engineering concepts to solve Engineering Problem.

You might also like