ASSIGNMENT-I
S.No Question Marks CO
1 Determine the expression for conversion of star to delta network. 1 CO1
2 State and explain Superposition theorem with suitable example. 1 CO1
3 State and explain Nodal Analysis with suitable example. 1 CO1
4 State and explain Thevenin’s theorem with suitable example. 1 CO1
5 State and explain Mesh Analysis with suitable example. 1 CO1
ASSIGNMENT-II
S.No Question Marks CO
1 Define impedance and admittance of RL Series circuit. 1 CO2
2 Define susceptance and conductance of RL Parallel circuit. 1 CO2
Prove that the average power consumed in a pure capacitor circuit is
3 1 CO2
zero.
4 Define the following terms: 1 CO2
i) RMS VALUE ii) PEAK VALUE
5 Define the following terms: 1 CO2
i) FORM FACTOR ii) POWER FACTOR
ASSIGNMENT-III
S.No Question Marks CO
1 Derive the expression for dynamically induced emf. 1 CO3
2 Explain Faraday’s law and Lenz’s law. 1 CO3
3 Compare Magnetic and Electric circuit. 1 CO3
4 Explain the following terms:- 1 CO3
i) Magnetic flux ii) Permeability
5 Explain the following terms:- 1 CO3
i) MMF ii) Flux Density iii) Magnetic field Intensity
ASSIGNMENT-IV
S.No Question Marks CO
1 Describe the constructional detail of three phase Induction Motor. 1 CO4
Explain why three phase induction motor cannot run at synchronous
2 1 CO4
speed.
Derive an expression of rotor frequency in terms of main supply
3 1 CO4
frequency and slip.
Compare induction machine and synchronous machine on the basis of
4 1 CO4
construction and application.
Describe D.C machine with suitable sketches in viewing of main parts
5 1 CO4
and construction details.
ASSIGNMENT-V
S. No Question Marks CO
1 Explain operation and truth table of J-K flip flop. 1 CO5
2 Explain different operating condition for a transistor. 1 CO5
3 Explain De Morgan’s theorem. 1 CO5
4 What is P-N junction diode? Sketch the V-I characteristics. 1 CO5
5 Explain Bipolar Junction Transistor (BJT) and their working. 1 CO5
TUTORIAL- I
S.No Question Marks CO
For the circuit shown in figure-1 determine the current I through the 5Ω
1 1 CO5
resistance by KCL.
For the circuit shown in figure-1 determine the current I through the 5Ω
2 1 CO5
resistance by KVL.
For the circuit shown in figure-1 determine the current I through the 5Ω
3 1 CO5
resistance by Thevenin’s theorem.
For the circuit shown in figure-1 determine the current I through the 5Ω
4 1 CO5
resistance by Superposition theorem.
5 Derive an expression for delta to star transformation. 1 CO5
Tutorial-II
S.No Question Marks CO
An AC has frequency of 50 Hz and current 25amp. Write equation of
1 1 CO2
instantaneous current. Find
i) Current at time=0.0025Sec
ii) Time at which current is 14.14 Amp
A 20mH inductor is connected in series with a 10Ω resistor across a
2 1 CO2
220V, 50 Hz supply. Find the current and power factor of the circuit.
A DC current of 1 amp passes through a series circuit of 1 Ω resistor and
3 1 mH inductor. What is the voltage across the circuit if the current were 1 CO2
a 50 Hz current then what will be the voltage?
4 Derive the expression for AC through RL series circuit. 1 CO2
5 Derive the expression of average power for purely inductive circuit. 1 CO2
TUTORIAL- III
S.No Question Marks CO
A 25KVA transformer has 500 turns on primary and 40 turns in
1 secondary windings, primary is connected across 300V, 50 Hz. 1 CO3
Calculate secondary and primary current at full load.
A 25KVA transformer has 500 turns on primary and 40 turns in
2 secondary windings, primary is connected across 300V, 50 Hz. 1 CO3
Calculate the secondary emf.
A 25KVA transformer has 500 turns on primary and 40 turns in
secondary windings, primary is connected across 300V, 50 Hz.
3 Calculate the maximum flux in case negligible magnetic leakage 1 CO3
resistance of winding and primary no load current as compare to full
load current.
A 100 KVA, 2400/240 V, 50Hz, single phase transformer has an
exciting current 0.64 Amp and a core loss of 700W when its high
4 1 CO3
voltage side is energized at rated voltage and frequency. calculate the
components of no load branch parameters.
A 1-phase transformer has 350 primary and 1050 secondary turns, the
net cross sectional area of the wire is 55 cm2 if the primary winding is
5 1 CO3
connected to 400v, 50 Hz, 1-phase supply Calculate (i)
Induced EMF (ii) Primary Voltage & Secondary Voltage.
TUTORIAL- IV
S.No Question Marks CO
A 4 pole lap wound armature has 144 slots with two coil sides per pole.
1 Each coil having two turns if the flux per pole is 20 Wb and the armature 1 CO4
rotates at 720 rpm. What is the induced emf.
A 4 pole lap wound armature has 144 slots with two coil sides per pole.
2 Each coil having two turns if the generator is running with 1200 rpm 1 CO4
then find the flux per pole, has 65 slots and 12 conductor per slots.
A 8 pole wave connected DC generator has 900 armature conductors and
3 flux per pole of 0.04wb at what speed it must be driven to generate 500 1 CO4
V.
Find the running speed of 4 pole Induction motor working on 50 Hz
4 1 CO4
supply having 3% slip.
The synchronous speed of induction motor is 1500 rpm and rotor speed
5 1 CO4
is 1440 rpm find slip.
Tutorial V
S.No Question Marks CO
1 Convert (110110)2 to its decimal equivalent. 1 CO5
2 Convert the following 1 CO5
(53.725)10=( )2
3 Convert (1375)10= ( )8 1 CO5
4 Convert (1101011)2 = ( )8 1 CO5
5 Convert (374.37)10 =( )16 1 CO5
