Test No.

Syllabus

PHYSICS

Q.123 In full wave rectification, the output DC is obtained across the load for.
A) Positive half of A.0 Complete cycle of A.0
B) Negative half of A.0 All of the above
If A.0 has frequency of 50Hz, then frequency of pulsating D.0 after full wave
Q.124
rectification will be:
50Hz A) 150Hz
100Hz 25 Hz
Waveform of A.0 is given as input. When it is passed through full wave rectifier, it
becomes:
Q.125

In a full-wave rectifier, which diodes conduct during positive half cycle of A.C

Q.126

X and W Z and X

Y and Z Either A or B
Q.127 By which process the depletion region is formed around the junction
Diffusion Fusion
Emission Fission
In the diagram, the input is across the terminals A and C and the output is across the
terminals B and D, then the output is B
Q.128

zero full wave rectifier

same as input half wave rectifier
If a full wave rectifier circuit is operating from 50 Hz mains, the fundamental frequency in the
Q.129
ripple will be
50 Hz 70.7 Hz
100 Hz 25 Hz
Q.130 Output of half wave rectifier is suitable only
To operate radio For running a D.C motor
Charging batteries All of these
Q.131 To reduce ripples in the output of bridge rectifier we should use
Diodes having low forward resistance Low frequency A.0
Diodes having high forward resistance A filter circuit
In fig. the current supplied by the battery is 200

Q.132

0.1 A 0.3 A
0.2 A 0.4 A
Q.133 In a bridge rectifier how many diode conduct during each half cycle of input A.C
2 1
3 All
In a half wave rectifier, the frequency of the input is N, the frequency and form of the
Q.134
output will be?
N/2 and Pulsating N and Pulsating
2N and steady N and continuous
The branch of physics which deals with the electrons and their flow through devices is
Q.135
3called
electronics electricity
electrostatics electro magnetism
Q.136 The types of rectifications are
3 4

The resistance of p-region of a diode is 6 Ω and the resistance of n - region is 3 Ω .The bulk
5 2
Q.137
 resistance is
3 ohm 18 ohm
9 ohm 1.5 ohm
Assuming diodes DI and D2 to be ideal, the current the current through them will be

Q.138

D1 = 0; D2 = 0.5mA D1 = 0.5mA; D2 = 0
D1 = 0.25 mA; D2 = 0.25 mA None
If the maximum forward current rating of diode is 4 mA , then diode

Q.139

Is safe May or may not be safe

Isn’t safe None
The number of valence electrons in silicon
Q.140
2 3
4 6
Q.141 Which one of the following is not an acceptor impurity?
aluminum iridium
boron gallium
Q.142 Mains A.C. power is converted into D.C power for?
Lighting purpose Heaters
Using in electronics None of the above
Q.143 The semiconductor diode can be used as a rectifier because
It has low resistance to the current flow when
It has low resistance to the current flow when
forward biased & high resistance when reverse
forward biased
biased
It has high resistance to the current flow when Its conductivity increases with rise of
reverse biased. temperature
Threshold wavelength for metal having work function 1eV is λ what is threshold
Q.144
wavelength for metal having work function 2eV is:
λ/2 4λ
2λ 2/4
Q.145 For the photoelectric effect, the maximum K.E Ek of the emitted photoelectrons is
plotted against the frequency n of the incident photons as shown in the figure. The slope
of the curve gives
 Charge of the electrons Work function of the metal
Ratio of the Planck's constant to electronic
Planck’s constant
charge
Photons with energy 5eV are incident on a cathode C in a photoelectric cell. The
maximum energy of emitted photoelectrons is 2eV. When photons of energy 6eV are
Q.146
incident on C, no photoelectrons will reach the anode A, if the stopping potential of A
relative to C is.
+3 V -1 V
+4V -3 V
The de Broglie wavelength of an electron accelerated to a potential of 400V is
Q.147 approximately.

0.03nm 0.04nm
0.12nm 0.06nm
Q.148 As the distance between source and cathode increases.
Kinetic energy of emitted photoelectrons
Photoelectric current decreases
decreases
Work function decreases All are correct
A proton, accelerated through a P.d 'V' has a certain de Broglie wavelength. In order to
Q.149 have the same De-Broglie wavelength, an α-particle must be accelerated through a
potential difference.
4V V/4
8V V/8
If the frequency of incident light beam falling on a photo emissive plate is doubled, then the K.E
Q.150
of the emitted photo electron is
Doubled more than doubled
Unchanged less than doubled
Figure represents a graph of kinetic energy (K) of photoelectrons (in eV) and frequency
(v) for a metal used as cathode in photoelectric experiment. The work function of metal

Q.151

1 eV 1.5 eV
2 eV 3 eV
Light of frequency 4.5f0 is incident on the metal of the threshold frequency f0. The
Q.152
maximum kinetic energy of the emitted photoelectrons is.
3 hf0 4.5 hf0
 5hf0 (7/2) hf0
Q.153 The minimum energy required to remove an electron is called.
Stopping potential Work function
K.E None
Q.154 The maximum energy of the electrons released a photo cell is independent of.
Frequency of incident light. Intensity of incident light
Nature of cathode rays None
Light of frequency 0.5 times the threshold frequency is incident on a photo sensitive
Q.155 material. If the frequency is halved and intensity is doubled the photo electric current
becomes.

4 times Double
Half Zero
An electron and a proton are accelerated through the same potential. If their masses are me and mp
Q.156
respectively then the ratio of their de-Broglie wavelength is
1 √ m p / me
m p / me me /m p
Q.157 The momentum of the moving photon is:
zero λ/h
h/λ hλ
Q.158 When wavelength of incident photon is decreased then
Velocity of emitted photo-electron decreases Velocity of photoelectron do not charge
Velocity of emitted photoelectron increases Photo electric current increases
Which one has the largest wavelength when all of the following moving with the same
Q.159
speed?
An electron An α – particle
A proton All have same de-Broglie wavelength
A material particle with a rest mass mo is moving with speed of light 'c'. The
Q.160 associated be-Broglie wavelength is given by:

h/moc 0
moc/h ∞
The frequency and work function of an incident photon are 'f' and φ0 respectively. If f0
Q.161 is the threshold frequency, then necessary condition for the emission of photo electron is
not.
f <fo f ≥ fo
fo = f /2 None
Q.162 The threshold frequency depends on the nature of:
Natural frequency Nature of material of anode
Photo-sensitive cathode Photon
Ultraviolet radiation of 7.1eV falls on an aluminum surface having work function φ =
Q.163
3.9eV. The Kinetic energy of the fastest electron emitted is.
4.7 eV 3.2 eV
8.2 eV 11.0 eV
Q.164 Stopping potential in photoelectric effect depends upon.
Photoelectric current Frequency of light
 Intensity of light All of these
Work function required of Aluminum is 4.2eV and for sodium is 2eV. These two
Q.165
metals are illuminated by same light, the threshold frequency of aluminum is.
Less than for sodium Greater than for sodium
Equal to that for sodium Data is not sufficient
If particles are moving with same momentum, then maximum de-Broglie wavelength will be:
Q.166
Neutron p - particle
Proton Same for all
Q.167 The wave nature of electrons was proposed by.
Davison and Germer De-Broglie
Einstein Thomson
The work function for certain surface is 6.625 eV the minimum frequency that light must
Q.168
have in order to eject electron from its surface is.
1.6x10-15H 1.6 x 1015 Hz
16 x 1019Hz 3.6 x 10-5 Hz
It takes 4.2 eV to remove one of the least tightly bound electrons from a metal surface.
Q.169 When UV photons of a single frequency strike a metal, electrons with kinetic energies
ranging from 0 to 2.6 eV are ejected. The energy of incident photon is.
2.6 eV 13.6 eV
6.8 eV 13.6/4 eV
The reverse process of photo electric effect
Q.170
annihilation of matter pair production
production of X-rays nuclear fission
Photon A has twice the energy of photon B. What is the ratio of the momentum of A to that of
Q.171
B?
2:1 1:2
1:1 None
The Davison and Germen experiment indicates
Q1.72
interference polarization
electron diffraction refraction
If E1,E2,E3 are the respective kinetic energies of an electron, an alpha-particle and a proton,
Q.173
each having the same de-Broglie wavelength then
El > E3 > E2 El > E2 > E3
E2 > E3 > El El = E2 = E3

Q.174 The magnitude of de-Brogile wavelength (λ) of electrons (e) proton (p) neutron n and 𝛂
particles all have the same energy 1 MeV, in increasing order will follow the sequence.
λe, λp, λn, λα λe, λp, λn, λβ
λα, λn, λp, λe λα, λp, λn, λe
Q.175 If the K.E of a free electron doubles then its de-Broglie wavelength changes by a factor
1/√2 √2
½ 2
The threshold frequency depends on the nature of.
Q.176
Natural frequency Nature of material of anode
Photo-sensitive cathode Photon