0% found this document useful (0 votes)
17 views2 pages

14-Aggregate Interfaces

Uploaded by

Ismail Kurnaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
17 views2 pages

14-Aggregate Interfaces

Uploaded by

Ismail Kurnaz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Aggregate Interfaces:

o Link aggregation (IEEE 802.3ad) enables to bind two or more physical interfaces together.
o Link aggregation bind two or more interfaces to form an aggregated (combined) link.
o The link aggregation(IEEE 802.3ad) new link has the bandwidth of all the links combined.
o If a link in the group fails, traffic is transferred automatically to the remaining interfaces.
o Major difference being that a redundant interface group only uses one link at a time.
o Where an aggregate link group uses the total bandwidth of the functioning links in group.
o Support of the IEEE standard 802.3ad for link aggregation is available on some models.
o An interface is available to be an aggregate interface if it is physical interface, not VLAN.
o It is not a Subinterface and it is not already part of an aggregate or redundant interface.
o it is in same VDOM as aggregated interface & Aggregate ports cannot span multiple VDOMs.
o it does not have an Internet Protocol IP address and is not configured for DHCP or PPPoE.
o it is not referenced in security policy, VIP, IP Pool or multicast policy & not HA heartbeat.

1 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


S1 LACP Configuration
S1(config)#interface range ethernet 0/0-1
S1(config-if-range)#switchport trunk encapsulation dot1q
S1(config-if-range)#switchport mode trunk
S1(config-if-range)#channel-protocol lacp
S1(config-if-range)#channel-group 1 mode active
S1# show etherchannel summary
S1# show etherchannel detail
S1# show etherchannel port-channel
S1#show spanning-tree vlan 1

2 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717

You might also like