Scribd
Upload
28 views2 pages

SUGABO, Self Check Module 2

Uploaded by

Alyssa Joyce
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
28 views2 pages

SUGABO, Self Check Module 2

Uploaded by

Alyssa Joyce
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

SUGABO, ALYSSA JOYCE M.

JULY 20, 2023


CSS NCT II

Module Title:
Using Hand Tools

SELF-CHECK 1.1
1. Enumerate the Policy Background to Plan Preparation
 Assessment
 Prevention
 Preparation of plans
 Education
 Testing/ Exercising
 Review
 Response

SELF-CHECK 2.1
Matching Type: Match the Hand Tools in Column A with its function in Column B.
Write your answer in sheet of paper.
Column A Column B
E 1. a tool used to hold small sensitive part of a computer.
D 2. a tool used for holding, bending and stretching the lead of electronics.
C 3. a tool used to unsolder unwanted parts of component.
B 4. a tool used to drive or fasten negative slotted screws.
A 5. a tool used to join two or more metal conductors with the support of soldering
lead.
J 6. a device used to exaggerate or to increase the size of an object.
I 7. a tool used to create network cable.
H 8. a tool used for cutting wires.
G 9. a tool for cutting or trimming of connecting wires.
F 10. a key piece of safety gear that helps to prevent the buildup of static electricity.

SELF-CHECK 3.1
Directions: Fill in the blanks with the correct answer from the pool below.
1. If you experienced the grounding, the AC POWER CORD should be unplugged.
2. Replace the cover after performing service on the COVER SYSTEM.
3. When the cover system is damaged OVERHEATING is likely to happen.
4. You are working on a computer with damaged insulation, you will likely to
experience ELECTRIC SHOCK.
5. You should wear a WRIST STRAP when handling printers circuit boards.

SELF-CHECK 4.1
Direction: Use your answer in a sheet of paper.
B 1. Keep hand tools clean and free from _____ and _____.
a. dirt and dust c. water and soda
b. ferrous and other contaminants d. none of the above
B 2. Do not use hand tools in direct contact with _________, due to the possible
formation of explosive acetylides, especially the presence of moisture.
a. acetone c. alcohol
b. acetylene d. none of the above
A 3. If you used a damage hand tool, what will you do?
a. tag a tool c. put in a trash can
b. don’t use it d. none of the above
C 4. As part of the normal operating and safety procedure, these tools should be
returned to the __________.
a. bedroom c. workshop
b. office d. none of the above
C 5. When sharpening hand tools, follow normal _____ procedure.
a. friendly c. safety
b. common d. unsafe

You might also like