0% found this document useful (0 votes)
6 views15 pages

ECE 131 Lecture 0

Download as pdf or txt
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 15

Lecture 0

BASIC ELECTRICAL AND ELECTRONICS


ENGINEERING
ECE-131
•Welcome !
Practical Applications of the Subject
The course contents
Unit I
Fundamentals of D.C. circuits:
resistance, inductance, capacitance, voltage, current, power and energy concepts, ohm's law,
Kirchhoff’s laws, basic method of circuit analysis, intuitive method of circuit analysis- series and
parallel simplification, voltage division rule, current division rule, star–delta transformation, mesh and
nodal analysis, introduction to dependent and independent sources, network theorems- superposition
theorem, Thevenin’s theorem, Norton’s theorem, maximum power transfer theorem

Unit II
Fundamentals of A.C. circuits:
alternating current and voltage, concept of notations ( i, v, I, V), definitions of amplitude, phase, phase
difference, RMS value and average value of an AC signal, complex representation of impedance,
steady state analysis of ac circuits consisting of RL, RC and RLC (series), resonance in series RLC
circuit, power factor and power calculation in RL, RC and RLC circuits, three-phase circuits-
numbering and interconnection (delta or mesh connection) of three phases, relations in line and
phase voltages and currents in star and delta
The course contents
Unit III
Fundamentals of electrical machines:
Fleming’s left hand and right hand rule, mutual inductance and mutual coupling phenomena in
transformer, transformer – working, concept of turns ratio and applications, transformer on DC,
instrument transformers, auto-transformer, dc machines- working principles, classification,
starting, speed control and applications of dc motors, working principle of single and three phase
induction motors, applications of ac motors

Unit IV
Fundamentals of semiconductor devices and digital circuits:
digital abstraction- voltage levels and the static discipline, boolean logic, combinational gates,
fan-in and fan-out of gates, noise margin in details, pn junction and zener diode characteristics
and analysis, testing of diodes and its applications, basic operation and testing of BJT, MOSFET
representation and its characteristics, handling of integrated circuits-ESD phenomena
The course contents
Unit V
Fundamentals of filters and operational amplifier:
filter examples- band-pass filter, low-pass filter, high-pass filter, operational amplifier abstraction-
device properties of the operational amplifier, simple op amp circuits – virtual ground concept,
inverting and non-inverting op-amp, op-amp as an adder and subtractor, op-amp RC circuits –
op-amp integrator, op-amp differentiator, op-amp as a comparator and its application in anti-lock
braking systems

Unit VI
Fundamentals of embedded system and its application in industrial processes:
comparison of microprocessor and micro-controller, types of processors : SOC, ASIC, DSP and
FPGA, introduction to embedded system, examples of real-time applications of embedded
system : GPOS and RTOS, cyber physical world, role of IOT and cloud computing in condition
monitoring of plant processes, health care, agriculture, manufacturing, automobiles and smart
grid
Fundamentals of D.C. Circuits -Unit 1

Unit 1

Revising the basic formulas


Fundamentals of A.C. Circuits -Unit 2
Unit 2

Parallel R-L-C Circuit


Voltmeter

Ammeter
Series R-L-C Circuits
Fundamentals of Electrical Machines-
Unit 3
Unit 3

Transformer Two Pole D.C. machine


Fundamentals of semiconductor devices :
and Digital Circuits Unit 4
Unit 4
Fundamentals of Filters and
Operational amplifier - Unit 5
Unit 5
Fundamentals of embedded system and
its application in industrial
processes - Unit 6
Unit 6
Evaluation System

• Attendance : 5
• Continuous Assessment (CA):30
Best 2 out of 3
• Mid Term Exams: 25
• End Term Exams: 40
Text Books:
1. FOUNDATIONS OF ANALOG AND DIGITAL ELECTRONIC CIRCUITS by AGARWAL, ANANT,
AND JEFFREY H. LANG., ELSEVIER

References:
1. FUNDAMENTALS OF ELECTRICAL ENGINEERING AND ELECTRONICS by B.L.THERAJA, S.
CHAND & COMPANY

2. INTRODUCTION TO ELECTRONICS by EARL GATES, DELMAR - CENGAGE LEARNING

3. BASIC ELECTRICAL ENGINEERING by D.C. KULSHRESTHA, MC GRAW HILL

4. INTRODUCTION TO EMBEDDED SYSTEMS by K. V. SHIBU, MC GRAW HILL


Get Set Go!!!
Gear up
Fasten your seat belts

Build futuristic solutions

You might also like