Scribd
Upload
10 views3 pages

Ed Iat 1 QP

Ed qp 1

Uploaded by

Harini Ritz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
10 views3 pages

Ed Iat 1 QP

Ed qp 1

Uploaded by

Harini Ritz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

SET - A

DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING


BATCH (2022 - 2026): III Year/ V SEM
EE3012-ELECTRICAL DRIVES (R-2021)
INTERNAL ASSESSMENT TEST - I
DATE: 24.09.2024 TIME: 1.45 HRS TOTAL MARKS: 60

PART A: (6X2=12 Marks)


1. List out various components used in electric drive system.(C306.1, PO1, PO7)
2. What is dynamic torque?(C306.1, PO1, PO7)
3. What are the advantages of electrical drive? (C306.2, PO1, PO7)
4. What are the uses of phase controlled rectifiers in dc drives? (C306.2, PO1, PO7)
5. What is the function of a Freewheeling diode in a phase controlled rectifier? (C306.2,
PO1, PO7)
6. What is discontinuous Conduction mode?(C306.2, PO1, PO7)

PART B: (4X12=48 Marks)


1. Explain the typical load torque characteristics of electrical drives. (C306.1, PO1,
PO7)
2. Derive the mathematical condition for Steady State stability of equilibrium point.
(C306.1, PO1, PO7)
3. Discuss the different modes of operation of an electric drive. (C306.1, PO1, PO7)
4. Explain the steady state analysis of the single phase fully controlled converter fed
separately excited DC motor drive. (C306.2, PO1, PO7)

PREPARED BY- VALIDATED BY-


APPROVED BY-
SET - B

DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING


BATCH (2022 - 2026): III Year/ V SEM
EE3012-ELECTRICAL DRIVES (R-2021)
INTERNAL ASSESSMENT TEST - I
DATE: 24.09.2024 TIME: 1.45 HRS TOTAL MARKS: 60

PART A: (6X2=12 Marks)


1. Draw the block diagram of an electric drive system. (C306.1, PO1, PO7)
2. Write down the fundamental torque equation for dynamic electric drives (C306.1,
PO1, PO7)
3. What are the components of load torque?(C306.2, PO1, PO7)
4. Mention the different factors for the selection of choice of electric drives (C306.2,
PO1, PO7)
5. What are the causes poor input power factors in phase controller DC drives? (C306.2,
PO1, PO7)
6. Give the condition under which the DC motor operates under continuous current
mode (C306.2, PO1, PO7)

PART B: (4X12=48 Marks)


1. Explain in detail with an example(low speed hoist) multi quadrant dynamic in the
speed torque plane (C306.1, PO1, PO7)
2. Write down the characteristics of different types of loads (C306.1, PO1, PO7)
3. Discuss the different modes of operation (a) Steady state (b)Acceleration including
starting (c) Deceleration including stopping (C306.1, PO1, PO7)
4. Explain the discontinuous and continuous mode of operation of single phase fully
controlled converter fed DC motor with necessary waveforms.(C306.2, PO1, PO7)

PREPARED BY- VALIDATED BY-


APPROVED BY-

You might also like