STATUS LEDS AND BUTTONS (1) DIGITAL I/O SPECIFICATIONS EXAMPLE I/O DIAGRAMS

MX-E90
Industrial Vision Processor External Internal PC 5V

PCOM1 19

PCOM0 10
ECOM
O 15
O 13
O 11

I 15
I 13
I 11
O9

O7
O5
O3
O1
①

I9
I7
I5
I3
I1
②

18
17
16
15
14
13
12
11

9
8
7
6
5
4
3
2
1
DESCRIPTION
O channels
This guide covers MX-E90 Industrial Vision Processor models. The MX-E90 ③ 0 1

28
27

25
24
23

21
35

33

26

22
37
36

34

32
31
30
29

20
Protection
series Industrial Vision Processors offer the most powerful and flexible way to Circuit
solve even complex machine vision applications. ④ S Vin Bi-direction
diode

GND
GND
O 14
O 16

O 12
O 10

I 16
I 14
I 12
I 10
O8
O6
O4
O2

I8
I6
I4
I2
• Rugged IP20 housing ECOM
• Low Maintenance COM2: RX2/TX2 for data transmission,
1 Power Button, Green 3
• 16 Inputs and 16 Outputs status monitoring.
• Up to 8 GigE cameras Pin Color Code Signal Name
COM1: TX1/RX1 for
• Easily Accessed connectors
2 data transmission, status 4 HDD LED status, Yellow 1 Black Input 1
monitoring. Figure 1 - Input connection
2 Brown Input 3
SYSTEM SPECIFICATIONS Power Button: Press and release to turn on the unit or shut down the OS and
switch off the unit. Press and hold to switch off without the OS shutdown. 3 Red Input 5
Processor
4 Orange Input 7
Intel Core i7
Storage 5 Yellow Input 9
32 GB RAM – 128 GB SSD SUPPLY VOLTAGE CONNECTION (9)
6 Green Input 11
GigE camera ports
For MX-E90-8: 8 (all are PoE capable) Power Connector 7 Blue Input 13
For MX-E90-4: 4 (all are PoE capable) + 24VDC Supply Plus
8 Purple Input 15
For MX-E90-2: 2 (all are PoE capable) - 24VDC Supply Minus -++-
All MX-E90 Industrial Vision Processors have the following specifications: Chassis Grounding: Common pin for external source or ground of Input
Power 24 9 Gray
Connect to ground using a conductor with Supplied 1 to Input 16
• HD graphics (1920x1200) minimum 2.5 mm² cross-section. Power PCOM0
• 2 x 10/100/1000 Mbps Base-T Network Interface NPN: common pin for connecting inductive loads of
• Ethernet/IP, Modbus TCP, OPC, PROFINET communications supported 10 White
O 1 to O 8
• 2 x RS232 Serial port PNP: common pin for external voltage of O 1 to O 8
• 16 x Optically Isolated Digital In + 16 x Optically Isolated Digital Out, IMPORTANT NOTE: It is advised to use all 4 pins for power connection.
configurable NPN (sink) or PNP (source) output type. 11 Pink Output 1
• Microsoft Windows 10 IoT Enterprise 2016 64-bit 12 Light Green Output 3
13 Black/White Output 5
GENERAL VIEW MECHANICAL DIMENSIONS 14 Brown/White Output 7
15 Red/White Output 9
① ② ③ ④ ⑤ ⑥ ⑦ 175 16 Orange/White Output 11
14 13 17 Green/White Output 13
5
⑧ 18 Blue/White Output 15
Ø
10

PCOM1
Figure 2 - Output connection (sinking)
NPN: common pin for connecting inductive loads of
g o 19 Purple/White
14

O 9 to O 16
5

PNP: common pin for external voltage of O9 to O 16

150

20 Red/Black Input 2

186
230

21 Orange/Black Input 4

f 22 Yellow/Black Input 6
a
40

22

145 26 23 Green/Black Input 8

201
24 Gray/Black Input 10
s 25 Pink/Black Input 12
Internal External
175 26 Pink/Red Input 14
d 14
5
13
27 Pink/Blue Input 16
PCOMx

28 Pink/Green Isolated ground

Ø

1 Status lights and buttons 8 Chassis Grounding

10

+
2 LAN 1 9 Supply Voltage Connection 29 Light Blue Isolated ground
Polyswitch –
30 Light Blue/Black Output 2 (Source type)
14

USB 2.0 Port for USB Hardware

3 LAN 2 10 Ox
186
5

Key 31 Light Blue/Red Output 4 LOAD

150

192

4 USB 3.0: x8 11 37-pin D-Sub Digital I/O 32 Light Blue/Blue Output 6 350mA
Camera connectors: 33 Light Blue/Green Output 8
COM1 + COM 2 Cam 1-Cam 8 (MX-E90-8), Cam IGND
5 12 34 Gray/Red Output 10
2x RS-232 Serial port 1-Cam 4 (MX-E90-4), Cam1-
Cam2 (MX-E90-2) 35 Gray/Green Output 12
21

6 DVI for Monitor 13 Extra Digital Output Grounding 145 26 36 Purple/Black Output 14
3

201
7 VGA 14 CFast card for extended storage 37 Blue/Black Output 16 Figure 3 - Output connection (sourcing)
TECHNICAL DATA I/O CONFIGURATION CE COMPLIANCE CHINA ROHS TABLE OF RESTRICTED ELEMENTS

Camera communication uses Cat6 Ethernet cable and provides POE for M1xx CE marking states the compliance of the product with essential requirements
ELECTRICAL FEATURES
and E1xx cameras. Use only Datalogic provided cables. listed in the applicable European directive. Since the directives and applicable
Supply voltage (Vs) 9 ~ 36VDC standards are subject to continuous updates, and since Datalogic promptly
Nominal: 5.5 A at 24VDC COMMUNICATIONS adopts these updates, therefore the EU declaration of conformity is a living
Current Consumption document. The EU declaration of conformity is available for competent authorities
Maximum: 23A at 9VDC; 6A at 36VDC
Vision Program Manager (VPM) software installed on the processor is used to and customers through Datalogic commercial reference contacts. Since April
Digital Inputs 16 opto-isolated, see Digital I/O Specifications. create vision programs and configure input and output response. Refer to the 20th, 2016 the main European directives applicable to Datalogic products
Impact Reference Guide for programming details. require inclusion of an adequate analysis and assessment of the risk(s). This
Logic 0: 3V max evaluation was carried out in relation to the applicable points of the standards
Input Voltage
Logic 1: 10V min (30V max) or dry contact. DIGITAL I/O CABLES TERMINALS AND CONNECTIONS listed in the Declaration of Conformity. Datalogic products are mainly designed
for integration purposes into more complex systems. For this reason, it is under
Input Resistance 3.21kΩ the responsibility of the system integrator to do a new risk assessment regarding
Cable Part Number

Polybrominated diphenyl
On Current >3mA the final installation.
Digital I/O 37-pin to Terminal Block 248-0110 606-0675-xx

× 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。

ethers (PBDE)
多溴二苯醚
Off Current <1mA
Digital I/O 37-pin to pigtail (remove one end) 606-0675-xx WARNING

○ 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。

Current Maximum 8.5 mA @30VDC

O
O
Note: Do not disconnect the cable at the connector while power is on. This is a Class A product. In a domestic environment this product may cause
Isolation Protection 2500VDC
radio interference in which case the user may be required to take adequate
Optical isolation response measures.
100µsec
time
Overvoltage protection 70VDC EXTRA DIGITAL OUTPUT GROUNDING FCC COMPLIANCE

Load Voltage 5 ~ 40VDC The spring clamp connector on the I/O Card provides two extra connections that Modifications or changes to this equipment without the expressed written

Polybrominated biphenyls
Load Current 350mA (max per channel) are equivalent to the GND/PCOM pin on the 37-pin connector and are used to approval of Datalogic could void the authority to use the equipment.
increase the current tolerance on the I/O Card. The spring clamp pins should This device complies with PART 15 of the FCC Rules. Operation is subject to
3.28mA @ 12VDC be connected whenever the combined total output current is higher than 3.2A. the following two conditions: (1) This device may not cause harmful interference,
Input current

多溴联苯
6.71mA @24VDC and (2) this device must accept any interference received, including interference

(PBB)
The pin assignments are as follows: which may cause undesired operation.

O
O
16 opto-isolated (configurable sink-NPN or
Digital Outputs
source-PNP), see Digital I/O Specifications. Pin 1: PCOM, used in source type (PNP) connections

有毒有害物质或元素
Pin 2: GND, used in sink type (NPN) connections This equipment has been tested and found to comply with the limits for a
Format Opto-coupler isolated open emitter output
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
Residual Voltage Output On 2V or less (output current ≤mA) designed to provide reasonable protection against harmful interference when the
Optical isolation response equipment is operated in a commercial environment. This equipment generates,
100µsec uses, and can radiate radio frequency energy and, if not installed and used in
time

Chromium (Cr(VI)
accordance with the instruction manual, may cause harmful interference to radio
Camera interface GigE (up to 8 depending on model)

Hexavalent
communications. Operation of this equipment in a residential area is likely to

六价铬
USB Hardware Port USB 2.0 Port for USB Hardware Key cause harmful interference in which case the user will be required to correct the

O
O
interference at his own expense.
8x USB 3.0 ports for monitor, mouse and
USB Ports
keyboard EAC COMPLIANCE
Graphic Interface Intel® HD (1920x1200 resolution) VGA, DVI
Customs Union:
Host Communications:
The CU Conformity certification has been achieved; this allows the Product to

Cadmium
Serial Communications 2x RS-232 Serial Port (COM 1 + COM 2) Spring Clamp Connector Pin Definition bear the Eurasian mark of conformity.

(Cd)
镉

O
O

本表格依据 SJ/T 11364 的规定编制。

10/100/1000 Mbps Ethernet x 2
Ethernet Ethernet/RIP, Modbus, TCP, OPC, PROFINET
LEGAL NOTICES
communications supported. SUPPORT THROUGH THE WEBSITE
PHYSICAL FEATURES

Mercury
© 2021 Datalogic S.p.A. and/or its affiliates ♦ ALL RIGHTS RESERVED. ♦
Datalogic provides several services as well as technical support through its

(Hg)
汞

O
O
7.55 w x 5.74 h x 9.05 d (in) Without limiting the rights under copyright, no part of this documentation may be
Dimensions website. Log on to www.datalogic.com.
192 w x 145 h x 230 d (mm) reproduced, stored in or introduced into a retrieval system, or transmitted in any
form or by any means, or for any purpose, without the express written permission
Weight 4450 g For quick access, from the home page click on the search icon , and type in of Datalogic S.p.A. and/or its affiliates.

Lead (Pb)
the name of the product you’re looking for. This allows you access to download
Housing material Metal
Data Sheets, Manuals, Software & Utilities, and Drawings. Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A.

X
X
ENVIRONMENTAL FEATURES Hover over the Support & Service menu for access to Services and Technical in many countries, including the U.S. and the E.U.
Operating: 0° to +50° C (+32° to +122° F) Support.
Temperature
Storage: -20° to +70° C (-4° to +158° F) Datalogic shall not be liable for technical or editorial errors or omissions
PATENT contained herein, nor for incidental or consequential damages resulting from the

部件名称
金属部件
Relative Humidity 5 to 95%, non condensing
use of this material.

(如有)
See www.patents.datalogic.com for patent list.

面板
Vibrations
Random: 5 to 500Hz 3g This product is covered by one or more of the following patents:
(EN60068-2-64) Datalogic reserves the right to make modifications and improvements without

MX-E90
Utility patents: EP2517148B1, EP2649555B1, US10095951, US8888003, prior notification.
Vibrations Sine: Ramp to 2g from 5 to 15Hz US8915443, US9396404, US9495607, US9798948, ZL200980163411.X,

Panel (if any)

(EN60068-2-6) 15 to 500Hz 2g ZL201080071124.9

Metal Parts
Shock resistance
Half sine: 11ms (50g Max) SEALS

PART
(EN60068-2-27)
Mechanical protection The Industrial Vision Processor has seals in some areas. The seals must not be
IP20
(EN 60529) broken or removed for any reason. The sealed parts may be opened only and
SOFTWARE FEATURES exclusively by Datalogic. Breakage of these seals by a customer shall result in
immediate cancellation of the warranty on the entire Industrial Vision Processor.
Minimum Impact Software
12.2.0
Version Required WARRANTY
HARDWARE FEATURES
The warranty period for this product is 24 months. See General Terms and
CPU Intel® Core i7
Conditions of Sales at www.datalogic.com for further details.
System Memory DDR4 RAM 32GB.
Storage 128 GB SSD, 1 CFast slot.
821005993 Rev. D