Scribd
Upload
20 views2 pages

Mock Test TD QP

Uploaded by

padhaiiii21
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views2 pages

Mock Test TD QP

Uploaded by

padhaiiii21
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

DELHI PUBLIC SCHOOL JODHPUR

MOCK TEST (CHEMICAL THERMODYNAMICS )


Subject Chemistry
Class XI
MM 25 Time 45 MIN
General Instructions :
(i)Q. no. 1 to 5 are multiple choice question and carry 1 mark each.
(ii) Q. no. 6 is short answer question and carry 2 mark.
(iii) Q. no. 7 to 12 are long answer questions and carry 3 marks each.
1.

2. (more than one correct )

3.

4.
5.

OR
6. How much heat is required to raise the temperature of an aluminium vessel weighing 1.25 kg from 25°C to
55°C ? Molar heat capacity of Al is 24 J mol–1 K–1
7.

8. Extensive properties depend on the quantity of matter but intensive properties do not. Explain whether the
following properties are extensive or intensive. Mass, internal energy, pressure, heat capacity, molar heat
capacity, density, mole fraction, specific heat, temperature and molarity
9.

10. Calculate the standard enthalpy of formation of C2H4(g) from the following thermochemical equation:

11. An ideal gas is allowed to expand against a constant pressure of 2 bar


from 10 L to 50 L in one step. Calculate the amount of work done by the
gas.
(ii) If the same expansion were carried out reversibly, will the work
done be higher or lower than the earlier case? (Given that 1 L bar = 100
J)
(iii) Calculate the work done in same expansion and the change in
internal energy when 10 litre of ideal gas expands isothermally into
vacuum until its total volume is 50 litre?

You might also like