BAT Electrical Test Answers

` Applied Engineering Technology Initiatives Ltd
(…total engineering solution)

ELECTRICAL ASSESSMENT QUESTIONS
INSTRUCTION: Answer all Questions in your answer script. Don’t write on the question
paper.
5. The efficiency of an ideal transformer
Section A: Choose the most is
appropriate option a. 10%
NAME: OJOMO GBOYEGA JOSEPH b. 20%
PHONE : 08139678907 c. 50%
d. 100%
1. . A circuit that has the same voltage is
called 6. Star connection is used where
____________ ______________ starting current is
a. Series circuit require
b. Parallel circuit a. high
c. Series- parallel circuit b. low
d. Short circuit c. full supply
e. none of the above d. DC supply
2. The S.I unit of power is e. none of the above
________________ 7. . The force that makes current to flow
a. ampere in a circuit is _______________ (a)
b. ohm Power (b) Resistance (C) Ammeter (d)
Voltage
c. watt
8. The material that allows free flow of
d. volt
electron is ____________ (a)
e. none of the above conductor (b) insulator (c) rubber (d)
3. . Transformers are rated in a. Kw b. none of the Above
kVA c. Kv d. kA 9. . Auto transformer has how many
4. Reversing the phase supply of a 3- winding____________ a. 1 b. 2 c. 3
phase motor may result to d. 4
_________ 10. . What are the constant parameter of
a. single phasing a Transformer a. Voltage b. Current
b. overload c resistance d. Frequency
c. cable stray 11. . In a step up transformer, the
d. high voltage number of turns in the secondary
winding is____________ than the
e. rotation on the reverse primary winding a. less b. the same c.
direction more d. none of the above
`
12. Which of the following would not 17. Single phase Live – to – Neutral will
cause an overload relay to trip? produce voltage approximately
a. Worn bearings _____
b. Licked chains drive a. 12V
c. Stiffness of belt drive b. 90V
d. Short between two coils of the c. 330V
motor d. 400V
e. Single phasing e. 220V
13. Device that protect against short 18. How should voltmeter be
circuit is____ connected in circuit?
a. Contactor a. In series to the load
b. Changeover Switch b. In phase to the load
c. Distribution board c. In parallel to the load
d. Pattress d. Adjacent to the load
e. None of the above e. None of the above
14. A wet electric motor winding will 19. _____________ is an example of
result in____ inductive load
a. low resistance reading a. incandescent bulb
b. high resistance reading b. television
c. low voltage reading c. electric motor
d. high conductive reading d. LED
e. minimal current reading e. All of the above
15. The main purpose of fuse is to 20. The purpose of DB (Distribution
protect our system against board) are the following except
______________ ______________
a. Phase failure a. Balance load
b. Under voltage b. Distribute power
c. High current c. Connection point
d. Regulate load
1 e. Supply power
d. Short circuit current 21. Resistance connected in series will
e. All of the above produce ___
16. Line-to-line voltage in Nigeria is a. Low resistance
approximately b. Higher resistance
______________ c. Equal resistance
a. 24V d. Balanced resistance
b. 400V e. None of the above
c. 220V
d. 120V
e. 380V
2
`
22. Circuit breaker and relay are both 28. The longer the length of conductor
for short circuit protection _________
______________ (YES/NO) a. The lesser the resistance
b. The better the conductor
23. Resistance in parallel will produce c. The higher the resistance
__________ d. The higher the inductance
a. High resistance e. All of the above
b. Low resistance 29. Fuses are normally rated
c. Equal resistance in______________
d. All of the above a. Voltage
e. None of the above b. Ohms
24. Socket outlet can be connected in c. Farads
__________ d. Amperes
a. Radial and ring e. Resistivity
b. Ring and parallel 30. The best method of connecting a
c. Parallel and radial wire is:_____
d. Adjacent and alternate a. Using cellotape
e. Series and Parallel b. Using terminal block
25. . Transformer work on the principle of c. Using cable tie
a. Self-induction d. Using masking tape
b. Mutual induction e. None of the above
c. Conduction 31. An electric heater draws 3.5A from
d. None of the above a 110V source. The resistance of
26. Connecting live and neutral wire the heating element is
together will result to approximately ______________
______________ a. 385 ohms
a. Reduce voltage b. 38.5 ohms
b. Reduce current c. 385 ohms
c. Low resistance d. 3.1 ohms
d. Full current e. 31 ohms
e. Short circuit 32. …………….is used to monitor a 3-
27. On start up, induction motor draws phase line
current that is usually _______ its a. Phase failure relay
rated current b. Timer relay
a. equal c. Contactor
b. lesser d. Overload relay
c. 6 to 7 times e. All mentioned
d. 10 times 33. In a certain three wire Y-connected
e. 100 times generator, the phase voltages are
3
`
2kV. The magnitudes of the line 38. In a three-phase system, when the
voltages are______________ loads are perfectly balanced, the
a. 2000V neutral current is_____
b. 6000V a. zero
c. 666V b. one-third of maximum
d. 3464V c. two-third of maximum
e. 2001V d. at maximum
34. A certain appliance uses 350W. If it e. Infinity
is allowed to run continuously for
24 days, how many kilowatt-hours
of energy does it consume? 39. __________ is use to determine
a. 20.16kWh the speed of an electric motor
b. 201.6kWh a. tachometer
c. 2.01kWh b. megger
d. 8.4kWh c. thermocouple
e. 84kWh d. Voltmeter
35. Cable insulation damage in an e. Ammeter
electrical installation can result to 40. The best tool used to determine
__________ current draw by each phase of an
a. open circuit electric motor is _____
b. earth leakage fault a. ammeter
c. increase ability to conduct b. clamp meter
d. transformer fault c. oscilloscope
e. increase in earth resistance d. multimeter
36. One major advantage of star-delta e. megger meter
connection for industrial motor 41. the difference between induction
operation is ________ motor and synchronous motor is
a. low starting torque that induction motor is
b. low voltage starting a. not self-starting
c. reduced starting current b. self-starting
d. Increase the starting current c. costlier than synchronous
e. insulation damage d. can be used to correct power
37. When short circuit occurs factor
________ effect happen e. None mentioned
a. current become becomes zero 42. In a single phase motor system, the
b. voltage become minimal safety and control devise is
c. minimum current flows connected to the…………..
d. current flows in reserve direction a. common
e. maximum current flows b. start
c. run
4
`
d. common and start a. Direct on line
e. Start and common b. Star delta
43. Which is a standard connection for
three phase electric
motor______________
c. Direct connection to a 3-phase
d. Option (a) and (b)
e. Non mentioned
44. The act of converting ac to dc is called---RECTIFIER--------
45. The act of converting dc to ac is called ---INVERTER-------
Identify the following components (Nos 46 to

50)
46. ________RELAY________________
47. __________CONTACTOR________________________
48. ______________VOLTAGE MONITORING DEVICES____________________
49. ________VOLTAGE REGULATING DEVICES_______________________

50. ________________CONTACTOR________________

BAT Electrical Test Answers

Uploaded by

Copyright:

Available Formats

BAT Electrical Test Answers

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

BAT Electrical Test Answers

Uploaded by

Copyright:

Available Formats

` Applied Engineering Technology Initiatives Ltd

(…total engineering solution)

45. The act of converting dc to ac is called ---INVERTER-------

Identify the following components (Nos 46 to

49. VOLTAGE REGULATING DEVICES_______________

You might also like