Scribd
Upload
228 views3 pages

s3900 Series Reset Configuration and Recovery System Configuration

FS . com s3900-series-reset-configuration-and-recovery-system-configuration

Uploaded by

ariosvelez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
228 views3 pages

s3900 Series Reset Configuration and Recovery System Configuration

FS . com s3900-series-reset-configuration-and-recovery-system-configuration

Uploaded by

ariosvelez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Data Center, Enterprise & ISP Network Solution

S3900 Series
Reset Configuration and Recovery System
Configuration
Data Center, Enterprise & ISP Network Solution

Function introduction
Resetting a device usually means restoring the device's configuration to the factory configuration. In some cases, we
will need to use the device reset function, such as a one-click recovery after the switch test is completed.

Configuration Considerations
Table 1 shows examples of applicable products and versions
Series Product Support version

S3900 Series SW After 1.64

Command line reset


● Network Topo

● Configuration Steps

1) Connection Equipment

#Connect the PC and the switch to the network cable and the console port. Connect one end of the RJ-45 network ca
ble to the network card interface of the PC and the other end to the network port of the SW. Connect one end of the c
onsole cable USB to the USB port of the PC. One end of the RJ-45 is connected to the console port on the front panel
of the switch.

2) Download Configuration Software

#After the connection is completed, there we recommend the super terminal, putty or Secure CRT tool to configure
the switch.

3) Switch On and Use Login Software

#Energizing the switch, then open the installed login software, select the serial port of login mode, port
through the device manager to determine. Baud rate: 115200, Data bits: 8, Parity: None, Stop bits: 1. (Reference
below)

1
Data Center, Enterprise & ISP Network Solution

Note:
COM Number can be viewed through device manager. (right click on my computer. >manage>device
manager>port (COM and LPT）If it displays an unrecognized USB device, please download and install
the corresponding driver.

4) Landing Switch

#After following these steps, press the Enter key on the keyboard and enter the password of the account.
At this time, enter the default username and password admin/admin and then log in to the switch.

5) Restore default configuration

Switch#dir
Unit 1:
File Name Type Status Size Modified
--------------------------------------------------------------------------------
S3900-48T4S-MR-V0164.bin Image Active 19425748 2018-08-22 09:04:28
S3900-48T4S-R-P01B001V0156.bin Image InActive 19458516 2018-12-17 16:31:56
Factory_Default_Config.cfg Config InActive 525 2018-12-17 15:46:44
startup-config Config InActive 2550 2018-12-17 15:48:13
startup1.cfg Config Active 2498 2018-12-17 15:46:53
-------------------------------------------------------------------------------
Flash size: 128 MB
Switch#conf t
Switch(config)#boot system config: Factory_Default_Config.cfg
Switch(config)#delete file unit 1 name startup1.cfg
Switch(config)#exi
Switch#restart
System will be restarted. Continue <y/n>? y
Switch#

You might also like