Scribd
Upload
8 views2 pages

MPMC May 2019

Mpmc

Uploaded by

Madhu Mitha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
8 views2 pages

MPMC May 2019

Mpmc

Uploaded by

Madhu Mitha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
19. 20. Explain with neat diagram, the interfacing of Real time clock with 8051 Microcontroller. Or Design an automation system for providing water supply to a residential colony using PIC Microcontroller. 4 4626165, 4626165 B.Tech. DEGREE EXAMINATION, MAY 2019. Fifth/ Sixth Semester Electronics and Communication Engineering MICROPROCESSORS AND MICROCONTROLLERS (2003-08 and 2009-12 Regulations) ‘Time ; Three hours ‘Maximum ; 75 marks PART A — (10 x 2= 20 marks) Answer ALL questions. All questions carry equal marks. 1, List the maskable and non maskable interrupts available in 8085. S 2 What is the maximum memory size that ean be interfaced with 8085? Give reasons. 8, Compare serial and parallel data transfer. 4, What are the keyboard modes supported by keyboard and display controller? 5. Name the four modes of serial data transmission in 8051 10. uw 12, 13, Why are all the pins of a port loaded with value "FF in 8051 before using them? ‘What are the advantages of I'C bus? ‘What are the differences between CISC and RISC? ‘What is the use of ADC/DAC in a microcontroller based system? Mention the control signals required to interface ‘external memory with 8051 microcontroller. PART B — (6 11 = 55 marks) Answer ALL questions. All questions carry equal marks. With a neat diagram, elucidate the architecture of 8085 microprocessor. Or Interface two 8K x 8 RAM chips with the 8085, such that the memory address range assigned to them is 0000H — 3FFFH, using an address decoder having only logic gates. (@) Describe the different ports of 8255) Programmable Peripheral Interface with its functional diagram. ) () Mention the methods to detect the key: debouncing, 2 eae: Or : Bs 4626) u 1 16. MW. 18, (@) Write an 8085 assembly language program to display a character using 8279 keyboard and display controller. @ () Write down the sequence of operations for programming 8259 to interface with 8085 ‘microprocessor. @ List the different addressing modes in 8051 and explain each with an example. Or (@) Write an ALP for the given scenario, Assume that bit P2.3 is an input and represents the condition of micro oven, If it goes high, it means that the oven is hot. Monitor the bit continuously. Whenever it goes high, send a low to high pulse to port PIL6 to turn on a buzzer, ® (b) Why are the program counter (PO) and data pointer (DPTR) registers of 8051, 16-bit Wide, whereas the stack pointer register is only 8 bit wide? Give reasons. ® With necessary diagrams and an example, explain how the compare capture mode works in PIC microcontroller. Or Explain how the serial peripheral interface is used for interfacing devices and the process of data transfer with necossary diagrams, 3 4626165

You might also like