Scribd
Upload
29 views3 pages

Computer System Organization 2022

Uploaded by

blackcreator420
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views3 pages

Computer System Organization 2022

Uploaded by

blackcreator420
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

1945 June 2022 307/4(N)

COMPUTER SYSTEM ORGANIZATION


Full Marks: 60
Time Allowed: 3 Hours
Answer the following questions from Group-A, B&Cas directed.
GROUP-A
lx 10=10
1.Choose the correct alternative (Any ten)
as
1) The number successful accesses to memory stated as a fraction is called
a) Access rate b) Success rate c) Hit rate d) Miss rate

ii) The final addition sum of the numbers, 0110& 0110 is


a) 1101 b) 1111 c) 1001 d) 1010
Computer Speed Addition c) Carry
iii) What does CSA stands for? a) Computer Service Architecture b)
Save Addition d) None of these
as- a) Micro task b)Micro instruction c)Micro
iv) Individual control word of the micro routine are called
operation d)Micro Command

v) Which of the following circuit convert the binary


data into a decimal? a) Decoder b) Encoder c) Code
converter d) Multiplexer
available is called a) Data hazard b) Stock
vi) The situation wherein the data of operands are not
c) Deadlock d) Structural hazard
Instruction Sequential Compilation b) Complete
vii) What is the full form of CISC? a) Complex Sequential Compiler d) Complex Instruction
Instruction Sequential Compilation c) Computer Integrated
Set Computer
ADDI 5,R1;
instruction, ADD #5,R1 is-a) ADD (5],/RI]; b)
viii) The alternate way of writing the
way
c) ADDIME 5,[R1ll: d) There is no other
row at the same time, we make use of
ix) In order to read multiple bytes of a
register d) Latch
a) Memory extension b) Cache c) Shift
using
x) In full adders the sum circuit is implementedXNOR
XOR d)
a) And & or gates b) NAND gate c) None of the
Computer address bus is .a) Unidirectional b) Bidirectional c) Multidirectional d)
xi)
above
connects the CPU to a memory on the system board?
xii) Which of the following computer bus
System bus d) None of the above
a) Expansion bus b) Width bus c) are -
input port and writing an output port respectively
xii) The instructions that are used for reading an
c) IN, MOV, d) IN, OUT
a) MOV, XCHG, b) MOV, IN,
b) R1+R2 c) Both d) None
xiv) Micro operationisshown as: - a) Rl-R2

1
xv) An interrupt that can
a) Vectored interrupt b) be temporarily ignored is
Non-maskable interrupt c) Maskable interrupt d) High priority interrupt
2. Fill in the blanks
(Any ten):
i) is used to store data, 1x 10=10
ii is generally used to instructions and results permanently future use.
for
ii)Gray Code is also called as increase the apparent size of physical memory.
iv) Instruction register stores
v) A high speed memory is placed between the
vi) I/Oaddress in 8086 is CPU and the primary memory is known as
bit.
vi) Techniques that automatically move programs and data
are required for execution are called blocks into the physical memory when they
Viii) Hit ratio is maximum in
ix) The bias value for mapping
x) MOV AX,[2AS0] issingle-precision
an example of
floating point numbers is
xi) Loop addressing mode.
unrolling is a technique to improve_
xii) Page table resides in
xiii) Microinstruction consists of
xiv) The smallest entity of memory is called
xv) A source program is usually in language.
3. Answer the following question (any ten) 1x 10 =10
i)How control unit controls other units?
ii)Give an example of a 4 bit, 8bit, 16-bit, and 32 bit
iii) What is Bus?
microprocessor.
iv) What is MAR and MDR?
v) What is register?
vi)What is interrupt?
vii) What is non-volatile memory?
vii) What is logical address?
ix) Which is an error-detecting code?
x) What is the logic shift?
xi) What type of device converts digital signal into a form that is intelligible to the
xii) Which memory stores instruction which is required to start a computer? user?
xiii) Define clock rate.
xiv) What is the RAID system?
GROUP -B
4. Answer the questions (Any six)
2x6=12
i)) What are the three main elements of the control unit?
ii) What is Cache memory?
iii) What is control memory address?
iv) What is the 2's complement representation of -6?
v) What is clock signal in COA?
vi) Is USB is a bus?
vii) Draw the block diagram of the half adder.
viii) Draw a multiplication circuit diagram.
ix) What's the difference between interrupt service
x) What do you mean by the write-back policy?
routine and subroutine?
xi) What is RISC Pipeline?
xii) What size of MUXs are needed?

2
5. Answer the question (any one): GROUP -C
a) Explain the 6x1
components of the Computer system and
b) Represent (12.625)0 in 32 bit what is micro operation?
c) Describe the floating point representation and what is odd parity checker?
Von-Neumann Architecture with diagram? Explain the Bus Structure with examples
6. Answer the question (any one):
6x1
a) Describe the Flag Register of
b)Perform multiplication between 8086 microprocesso.
23
c) What are the key characteristics of and 17 using fixed point multiplication algorithm.
operation. micro-programmed control?Explain different types of micro
7. Answer the question (any one):
a) Discuss the various mapping 6x1
b) What is virtual memory? Howtechniques used in cache memory.
does it work?
c) How can you interface RAM and the ROM EPROM to
EPROM? microprocessor 8086? What is the use of

You might also like