PCCMapDataDownload USB-Stick
PCCMapDataDownload USB-Stick
Introduction
This manual describes how to
2. Install the latest map data onto a USB drive for map updates
Consult the Predictive Cruise Control (PCC) service manual for procedures for the following:
• Programming the USB installed map data into the PCC ECU
3/16/2016 Page 1 of 9
Download Instructions
1. From the Eportal homepage, navigate to the PCC software page (EportalService Tab (1) Software (2)
Predictive Cruise Control (3)).
2. Click on the “2016 Map Data” link to initiate the PCC map data download.
Select the arrow on the “Save” button in the pop-up to open the dropdown box and select “Save as” to save the
map data installer to the desired location.
3/16/2016 Page 2 of 9
PCC Map Data Download to USB Stick
3. Navigate to the desired folder to save the PCC map data installer. The desktop is the preferred location. Select
“Save” and allow the download complete.
Requirements
NOTE
PACCAR recommends the following USB sticks for PCC map updates. Un-
recommended USB drives have been known to cause unsuccessful map data
installations.
3/16/2016 Page 3 of 9
PCC Map Data Download to USB Stick
Procedure
1. Double click on the PCC map data in the folder where the download is saved.
2. A security check dialog box appears. Click on “Run” to continue the installation.
NOTE
It takes at least 3 minutes to prepare the USB stick for the map data
3. Select the language to be used during the installation and select “Next>” to start the installation process for the
PCC map data.
3/16/2016 Page 4 of 9
PCC Map Data Download to USB Stick
5. Connect the approved USB stick to the PC and wait until Windows recognizes it.
3/16/2016 Page 5 of 9
PCC Map Data Download to USB Stick
The data installation progress box appears. It may take up to 2 minutes to complete.
NOTE
The USB stick containing the map data can be used for an unlimited number of PCC map data updates if
the data is the latest available. Therefore, it is advised that the USB stick be labelled for easy recognition.
3/16/2016 Page 6 of 9
Download Instructions
2. Right click on the Windows “Start” button. Click on the “Open Windows Explorer” button.
3/16/2016 Page 7 of 9
PCC Map Data Download to USB Stick
4. Right click on “USB DISK” and then left click on the “Properties” tab.
5. The “Format USB DISK” menu box appears. Select “FAT32” file system and click “Start.”
3/16/2016 Page 8 of 9
PCC Map Data Download to USB Stick
3/16/2016 Page 9 of 9