1561546552enable Cost Centre in Purchase Voucher
1561546552enable Cost Centre in Purchase Voucher
1561546552enable Cost Centre in Purchase Voucher
Email : [email protected]
Branch Office
1
Tally, Tally 9, Tally9, Tally.ERP, Tally.ERP 9, Shoper, Shoper 9, Shoper POS, Shoper HO,
Shoper 9 POS, Shoper 9 HO, Tally Developer, Tally. Developer 9, Tally.NET, Tally
Development Environment, Tally Extender, Tally Integrator, Tally Integrated Network,
Tally Service Partner, Tally Academy & Power of Simplicity are either registered
trademarks or trademarks of Tally Solutions Pvt. Ltd. in India and/or other countries. All
other trademarks are properties of their respective owners.
Version: Alpha Automation Pvt. Ltd. /Enable Cost Centre in Purchase Voucher/1.0/ June
- 2019
2
Enable Cost Centre in Purchase Voucher – 1.0
Introduction
• By Default Tally Provides Selection of Cost Centre in Sales Voucher Entry. But, With
This add-on User get Facilities to Select Cost Centre in Purchase Voucher Entry also.
Important!
As a best practice it is advisable to back up your company data
Installation
System requirements:
3
Setup Guide:
For Tally.ERP 9 Series A Release 3.2 and above
Go to Gateway of Tally > F11: Features > Add-on Features
Set “Yes” to the option “Enable Cost Centre in Purchase Voucher?”
4
Detailed User Guide:
5
2. Gateway of Tally → Accounting Vouchers → Purchase (F9)
6
3. Cost Centre in Purchase Voucher Entry as shown below:
7
FAQ
If I need some enhancement / changes to be incorporated for the add-on, whom should I
contact?
Please to write to us on [email protected] with your additional requirements and we will
revert to you in 24 hours.
I am using a multi site. Can I use the same Add-on for all the sites?
No, one Add-on will work only for 1 site. You need to purchase again if you want to use the same
Add-on for more sites.
8
Product and Features Page shows errors with the Add-on, What do I do?
Check first if the error is because of the Add-on or because of clashes between 2 TDLs (An add-on
is also a TDL). In case of clashes, disable one or more TDLs and check which TDL has error. If the
Add-on has a problem, you can report it to us.
My Tally went into educational mode after installing the add-on. What do I do?
Go into Gateway of Tally → Press F12 → Select Product and Features -> Press F4 and
remove the Add-on from the list and Restart Tally.