Scribd Logo
Upload

Welcome to Scribd!

  • 21 views

    LS3 E38 ECU Pinout Sheet1

    Uploaded by

    Ali Khan

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    LS3 E38 ECU Pinout Sheet1

    Uploaded by

    Ali Khan
    21 views5 pages

    Original Title

    LS3-E38-ECU-Pinout-Sheet1

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    21 views5 pages

    LS3 E38 ECU Pinout Sheet1

    Uploaded by

    Ali Khan

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 5

    Chassis DT Chassis DTM

    1 Rev lights 1 12v constant +


    2 Coil 2 2 Speed sensor out
    3 12v constant + 3 tachometer
    4 - 4 MIL light
    5 Starter solenoid 5 ACC
    6 Coil 1 6 AC
    7 Inj power + 7 AC 0V
    8 Ecu/sensor + 8 AC 5v
    9 GND 9 fuel level
    10 Fan 1 Control 10 brake Light sw
    11 Fan 2 Control 11
    12 Fuel Control 12
    73 Pin Black E38 ecm Yellow= un-needed, Blue = standalone , Red = auto
    Pin Wire Function
    1 -- --
    2 -- --
    3 -- --
    4 -- --
    5 -- --
    6 -- --
    7 -- --
    8 -- --
    9 brn/wht Brake Switch Signal to brake switch at brake pedal, 12v+ hot with brakes applied. Open when NOT on the brakes.
    10 -- --
    11 -- --
    12 blu/red AC pressure signal (spare)
    13 grn/wht AC pressure 0V (spare)
    14 -- --
    15 -- --
    16 grn/blu Fuel Level (spare)
    17 grn/red High Speed Cooling Fan Relay Control
    18 -- --
    19 yel/blk Ignition 1 Voltage ECM 12v+ KEY Power
    20 wht/grn Battery Constant Voltage ECM 12v+
    21 -- --
    22 -- --
    23 wht/grn Low Reference - APP Sensor Pin A
    24 -- --
    25 -- --
    26 -- --
    27 wht High Speed GMLAN Serial Data Bus (-) obd2
    28 wht/blu High Speed GMLAN Serial Data Bus (+) obd2
    29 wht APP Sensor 1 Signal - APP Sensor Pin E
    30 wht Low Reference - APP Sensor Pin F
    31 wht/blk shield drain for pedal
    32 wht/blu APP Sensor 2 Signal - APP Sensor Pin B
    33 -- --
    34 yel/blu AC pressure 5V+ (spare)
    35 -- --
    36 wht/orng 5-Volt Reference 1 - APP Sensor Pin C
    37 red/yel IAT Sensor Signal - MAF Pin D
    38 grn/wht Low Reference - MAF Pin E (for IAT)
    39 -- --
    40 -- --
    41 grn/blk MAF Sensor Signal - MAF Pin A
    42 -- --
    43 -- --
    44 -- --
    45 -- --
    46 -- --
    47 yel/blk Ignition 1 Voltage ECM 12v+ KEY Power
    48 blu TACH SIGNAL OUTPUT
    49 -- --
    50 grn/yel Fuel Pump Relay Control
    51 -- --
    52 -- --
    53 -- --
    54 -- --
    55 -- --
    56 wht/red 5-Volt Reference 2 - APP Sensor Pin D
    57 blu/wht VSS Out
    58 grn Low Speed Cooling Fan Relay Control
    59 -- --
    60 -- --
    61 -- --
    62 -- --
    63 -- --
    64 blk/red AC Control
    65 -- --
    66 -- --
    67 -- --
    68 grn/orng MIL Control - "Service Engine Soon" Computer supplies GROUND to turn on light
    69 -- --
    70 -- --
    -- --
    71 blu/red VSS High Signal - TO SPEED SENSOR ON MANUAL TRANS
    72 blu/blk VSS Low Signal - TO SPEED SENSOR ON MANUAL TRANS
    73 blk Ground

    80 Pin Grey
    Pin Wire Function
    1 -- --
    2 wht/orng Crankshaft 5V Pin C
    3 yel/blu 5-Volt Reference 2 - Throttle Body Pin E
    4 -- --
    5 wht TAC Motor Control - 2 - Throttle Body Pin A
    6 wht/blu TAC Motor Control - 1 - Throttle Body Pin B
    7 -- --
    8 -- --
    9 -- --
    10 -- --
    11 grn/yel Reverse Lockout solenoid
    12 red/blu HO2S Heater Low Control - Bank 1 Sensor 1
    13 red/blu HO2S Heater Low Control - Bank 2 Sensor 1
    14 -- --
    15 -- --
    16 -- --
    17 yel Fuel Injector 8 Control
    18 brn Fuel Injector 5 Control
    19 red Fuel Injector 6 Control
    20 brn Fuel Injector 1 Control
    21 red/wht ECT SSignal - ECT Pin B
    22 grn/wht ECT 0V Pin A
    23 -- --
    24 -- --
    25 -- --
    26 wht KS 1 Signal - KS1 Pin A
    27 wht/blu KS 1 Signal - KS1 Pin B
    28 -- --
    29 wht KS 2 Signal - KS2 Pin A
    30 wht/blu KS 2 Signal - KS2 Pin B
    31 -- --
    32 wht/blu Generator Field Duty Cycle Signal
    33 -- --
    34 grn/wht Oil Pressure 0V Pin 1
    35 grn/wht Low Reference - Throttle Body Pin C
    36 -- --
    37 red Fuel Injector 2 Control
    38 blu Fuel Injector 3 Control
    39 yel Fuel Injector 4 Control
    40 blu Fuel Injector 7 Control
    41 yel/blu Oil Pressure 5V Pin 2
    42 -- --
    43 yel/blu MAP 5V Pin C
    44 wht/orng Camshaft 5V Pin A
    45 -- --
    46 -- --
    47 -- --
    48 -- --
    49 -- --
    50 yel/red Oil Pressure Signal Pin 3
    51 -- --
    52 wht/blk Shield drain
    53 grn/wht MAP 0V Pin A
    54 -- --
    55 -- --
    56 wht/yel HO2S Low Signal - Bank 1 Sensor 1
    57 wht/red HO2S High Signal - Bank 1 Sensor 1
    58 grn/red MAP Sensor Signal Pin B
    59 wht/red HO2S High Signal - Bank 2 Sensor 1
    60 wht/yel H02S Low Signal - Bank 2 Sensor 1
    61 blk/yel Alt Charge Indicator Signal 12V turn on
    62 -- --
    63 wht/blu TP Sensor 2 Signal - Throttle Body Pin F
    64 wht Camshaft Signal Pin C
    65 wht TP Sensor 1 Signal - Throttle Body Pin D
    66 wht/blu Camshaft 0V Pin B
    67 -- --
    68 wht Crankshaft Signal Pin A
    69 wht/blu Crankshaft 0V Pin B
    70 brn IC 1 Control
    71 yel IC 8 Control
    72 blu IC 7 Control
    73 red IC 2 Control
    74 red IC 6 Control
    75 brn IC 5 Control
    76 yel IC 4 Control
    77 blu IC 3 Control
    78 grn/wht Low Reference - Coil Connector Pin E Odd Bank
    79 grn/wht Low Reference - Coil Connector Pin E Even Bank
    80 -- --

    You might also like