HT12D and Ht12e
HT12D and Ht12e
LabsGuru
Technologies 2012
HT12D IC............................................................................................................................................................. 2
1. Introduction.....................................................................................................................................2
2. Features:..........................................................................................................................................2
3. Pin diagram & block diagram...........................................................................................................3
HT12E IC............................................................................................................................................................. 3
1. Introduction.....................................................................................................................................3
2. Features:..........................................................................................................................................4
3. Pin Diagram & block diagram...........................................................................................................4
HT12D IC
1. INTRODUCTION
The 1212 decoders are a series of CMOS
LSIs for remote control system
applications. They are paired with Holtek
1212 series of encoders. For proper
operation, a pair of encoder/decoder with
the same number of addresses and data format should be chosen. The decoders receive serial
addresses and data from a programmed212 series of encoders that are transmitted by a carrier
using an RF or an IR transmission medium. They compare the serial input data three times
continuously with their local addresses. If no error or unmatched codes are found, the input data
codes are decoded and then transferred to the output pins. The VT pin also goes high to indicate
a valid transmission. The 212 series of decoders are capable of decoding information that consists
of N bits of address and 12 N bits of data. Of this series, the HT12D is arranged to provide 8
address bits and 4 data bits.
2. FEATURES:
Operatingvoltage:2.4V~12V
Low power and high noise immunity CMOS technology
Low standby current
Capable of decoding 12 bits of information
Binary address setting
Received codes are checked 3times
Address/Data number combination 8address bits and 4 data bits
Built-inoscillatorneedsonly5%resistor
HT12E IC
1. INTRODUCTION
The 212 encoders are a series of CMOS
LSIs for remote control system
applications. They are capable of
encoding information which consists
of N address bits and 12_N data bits.
Each address data input can be set to
one of the two logic states. The
programmed addresses data are transmitted together with the header bits via an RF or an infrared
transmission medium upon receipt of a trigger signal. The capability to select a TE trigger on the
HT12E or a DATA trigger on the HT12A further enhances the application flexibility of the 2 12 series
of encoders.
2. FEATURES:
Operating voltage 2.4V~12V for the HT12E
Low power and high noise immunity CMOS technology
Low standby current: 0.1_A (typ.) at VDD=5V
HT12A with a 38kHz carrier for infrared transmission medium
Minimum transmission word four words for the HT12E
Built-in oscillator needs only 5% resistor
Data code has positive polarity
Minimal external components
HT12E: 18-pin DIP/20-pin SOP package