Scribd
Upload
8 views

Function Generator

Uploaded by

bhayyaupwala
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
8 views

Function Generator

Uploaded by

bhayyaupwala
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

FUNCTION GENERATOR

The function generator is an instrument which generates different types of waveforms


The frequency of these wave orms can be vane over wide range. le most required
common waveforms are sine wave, sawtooth wave, triangular wave, square wave. These
various OlltputS of the generator are available simultaneously. We may require square
wave for testing linearity measurements in audio system. At the same time, we mal'
require!"~awtooth output to drive horizontal deflection amplifier of an oscilloscope which
gives visual display of the measurements. The purpose of providing simultaneous wavesis
flllfilled by the function generator.

Block Diagram:
The frequency controlled voltage is used to regulate two current sources namely upper
current source and lower current source. The upper current source supplies constant
current to an integrator. The output voltage of integrator then increases linearly with time.
If the current, charging the capacitor increases or decreases, the slope of output voltage
increases or decreases respectively. Hence this controls frequency. The voltage comparator
multivibrator circuit changes the state of the network when the output voltage of
integrator equals the maximum predetermined upper level. Because of this change in state,
the upper current source is removed and the lower current source is switched ON. This
lower current source supplies opposite current to the integrator circuit. The output of
integrator decreases linearly with time. When this output voltage equals maximum
predetermined upper level on negative side, the voltage comparator multivibrator again
changes the condition of the network by switching OFF the lower current source and
switching ON the upper current source.
The output voltage of the integrator has triangular waveform. The frequency of this
triangular waveform is determined by the magnitudes of the currents supplied by upper
current source and lower current source. To get square wave, the output of the integrator

is passed through comparator. The voltage comparator delivers square wave output
voltage·of same frequency as that of input triangular waveform. The sine wave is derived
from triangular wave. The triangular wave is synthesised into sine wave using diode
resistance network. In this shaper circuit, the slope of triangular wave is changed as its
arr'plitude changes. This results in a sine wave with less than 1% distortion.
The two output amplifiers provide two simultaneous, individually selected outputs of
any of the waveform functions.
The function of a signal generators is to supply signals of known amplitude and
known frequency. The signal generators are used to supply signal levels at very low levels
for the testing of receivers. But it is very difficult to measure and calibrate a signal at a
very low level. Thus attenuators are used in function generators. It is a device which
reduces power level of a signal by fixed amount.

Source : http://elearningatria.files.wordpress.com/2013/10/ece-iii-electronic-instrumentation-10it35-
notes.pdf

You might also like