0% found this document useful (0 votes)
51 views3 pages

Inter Part-1 (March 2019)

Uploaded by

Muhammad Imran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
51 views3 pages

Inter Part-1 (March 2019)

Uploaded by

Muhammad Imran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

GOVERNMENT MILLAT DEGREE COLLEGE MULTAN

(March Test 2019)


Subject: Computer Science Time Allowed: 20 Minutes
Intermediate Part-I OBJECTIVE Maximum Marks: 15

Name:________________________ Roll No.__________

Note: Circle the correct answer among four possible options given against each question.

1. The piece of hardware that permanently holds data and programs is called:
a. Primary Storage b. CPU c. Secondary Storage d. Output
2. CPU is an example of :
a. Software b. Program c. Hardware d. None
3. Which of the following is not an output device?
a. Scanner b. Printer c. Monitor d. Speaker
4. The dots that compose the image of digital photograph are called:
a. Dot Matrix b. Resolutions points c. Pixels d. Digital Points
5. What comes after the analysis phase in the SDLC?
a. Implementation b. Design c. Testing d. Support
6. Each computer on a network is called:
a. Bus b. Terminator c. Node d. None
7. NIC stands for:
a. Network Internal Card b. Network Industrial Computer
c. Network Internet Connection d. Network Interface Card
8. The most commonly used internet protocol is:
a. Ethernet b. Token Ring c. ARCnet d. All
9. FDDI is
a. Ring Network b. Star Network c. Mesh Network d. Bus Network
10. Which of the following is not a network communication device?
a. Router b. Hub c. LAN d. NIC
11. The electromagnetic or light waves representing date are called:
a. Information b. Signal c. Sender d. None
12. How many Characters ASCII 7-bit code can represent?
a. 128 b. 256 c. 500 d. 364
13. Which of the following technique uses modulation?
a. Bandwidth b. Broadband c. Bandwidth d. None
14. EBCDIC stands for
a. Extended Binary Coded Decimal Interchange Code
b. Extended Bit Code Decimal Interchange Code
c. Extended Bit Case Decimal Interchange code
d. Extended Binary Case Decimal Interchange Code
15. The term baud is measured of:
a. Speed at which data travels over communication line
b. Memory capacity
c. Instruction Execution Time
d. All
GOVERNMENT MILLAT DEGREE COLLEGE MULTAN
(March Test 2019)
Subject: Computer Science Time Allowed: 2.10 Hours
Intermediate Part-I Maximum Marks: 60
Subjective

Name:________________________ Roll No.______________

NOTE: Write same question number and its part number on answer sheet as given in the question paper.
SECTION-I
Q. No.2 Attempt any six parts. 6 X 2 = 12
i. What is information? Give its example.
ii. Define Bar Code Reader?
iii. What is difference between Soft Copy and Hard Copy?
iv. Write short note on Digital Camera.
v. What is Data Processing? Give its example
vi. What is digitizer / Graphics tablet?
vii. What is difference between Input Devices and Output Devices?
viii. What is plotter?
ix. Define Laser Printer
Q. No.3 Attempt any six parts. 6 X 2 = 12
i. Define Computer Network.
ii. What is workgroup Computing?
iii. What is Internet?
iv. Write Short note on HTTP.
v. What is E-Mail?
vi. Define WWW.
vii. Define Star Topology.
viii. Write short note on TCP/IP.
ix. Define Bus Topology.
Q. No.4 Attempt any six parts. 6 X 2 = 12

i. Define Data Communication.


ii. How data is represented in a computer?
iii. What is meant by encoding of data?
iv. Define bit and byte.
v. What is Serial Data Transmission
vi. What is Coaxial Cable
vii. Define Modulation and Demodulation.
viii. Define Broadband.
ix. Define Baseband
SECTION-II
Note: Attempt any three questions. 8 X 3 = 24
5. What is software? Describe different categories / types of Softwares.
6. What is impact printer? Discus different types of impact printers.
7. What is SDLC? Discus its different phases.
8. What is difference between LAN and WAN.
9. What is Data Transmission mode? Explain its types with example.

You might also like