RegNo.

: Name:

APJ ABDUL KA#$fi

qPEE?$(8f889.*.*'"*t*
Third Semester B.Tech Degree Examination December 2020 (2019

Course Code: EET201

Course Name: CIRCTIITS AI\ID I\IETWORKS
'Max. Duration: 3 Hours
Marks: 100

PART A
\ Answer all questions. Eoch question carrics 3 morks Marks

1. State and explain maximum power transfer theorem in DC circuits. (3)

2. Replace the network given below with a single current source and a resistor. (3)
A

3. Explain the classification of series RLC circuits based on damping ratio. (3)

4. Obtain the expression for the voltage across a capacitor discharging through a (3)
resistor of resistance R. Assume that the initial voltage of the capacitor is 7s.
5. Determine the voltale u(t) across a 2() resistor, if the current is given by,. (3)
2s*4
l(s)=F+4s+3
6. Derive the s-domain equivalent circuit of a capacitor having an initial voltage of 70. (3)

7. Explain the phenomenon of neutral shift in three phase 3 - wire systems. (3)

8. Derive an expression for the Q- factor of series resonant circuits. (3)

9. Express ABCD p4rameters in terms of Z parameters. (3)

10. Determine whether the two port network represented by the following network (3)
equations is reciprocal.
Vt=3Vz-2Iz
\= 4Vz-3Iz
PARTB I
Answer any one fuII quegionfrom each module. Each question carries 11 murks
Module 1

I I For the network given below,

a) Obtain the Thevenin's equivalent circuit across the terminals A and B. (10)

Page I of4

Downloaded from Ktunotes.in

 wry8T201122ffi6

b) Determine the power dissipated in the 2f) resistance. (4)

' 12 In the circuit given below,

a) Find the curr€nt i using superposition thesrem. (10)
q.
b) Determine the power supplied by the 20V source (4)

'l

Module 2
13 a) A series RL circuit with R :
10O is connected to a 50V DC supply at t = 0. (7)
Deterrnine the value of the inductancc L if the current through the inductor
attains 50% of its stsady state value in I seconds.
b) The switch K in the circuit given below haq been at position 1 for a long time. (7)
At t = 0, the switch is moved to position 2. Determine the current flowing
through the indrrctor for t > O.

4r) K

10v 20 0.5H
1F

t4 For the circuit shown beloq the switch K initially at position I for a long
time, is changed to position 2 at time t: 0. Using Laplace transform
technique,
a) Find the circuit cunent f (t) for t> O. (8)
b) Obtain the expression for the voltage 7"(t) across the 0.5F capacitor. (6)

Page 2 of 4

Downloaded from Ktunotes.in

 0&}EET201r22t06

%{t}

Module 3
1) a) ln the circuit given berow, find the cunent flowing
through the -i1o capacitor. (10)
4Q jso
q.

iI
50L00v

b) In the circuit given below, the switch K is closed

at t = 0, when the initial (4)
curr€nt through the indrrcor is zero and initial
vortage on thecapacitor is 4 v.
Draw the fiansfonned circuit for t ) 0 and write
the mesh equations in s_
domain.

t6 The switch K in tFe circuit given berow is in crosed position for a rong tirne.
At f = O,theswittr i" dp";.
a) Determirrc the transformed circuit for t ) O-
(4)
b) Find the expression for the voltage across the inductor, for t ) 0, using nodar (10)
analysis.

Page 3 of4

Downloaded from Ktunotes.in

 080EET201122ffi6

Module 4

t7 Aresistor,capacitorandaninductorarecolmectedinserieswitha2S0V'
frequency is varied to 50Hz' a
variable frequency AC source'. When the supply
voltage across the
maximum curr€nt of 2A flows and the corresponding
capacitor is 500 V- Determine,
(6)
(ijResistance, inductance and capacitance of the circuit'
(4)
(ii)Q- factor and bandwidth of the circuit
1 (4)
.\
(iii)TheSourcefrequenciesatwhichthecircuitcurrent'"atimesthe
maximum current-

(. 18 A400V,threc.phasesupplyfeedsanunbalancedthree-wire,star-connected(14)
1I0A' Zv = -iSA and
load. The branch i-p.d"n"", of the load are Zn =
.7
Zs = itSA. Calculate the line currents'
Module 5
19 a) Find the fiansmission parameters ofthe network
shown in the figure' (8)

Ir 6fl 12

given below' (6)

b) Find the driving point impedance of the network

20 a) Discuss dre series and cascade interconnection

of two port networks' (8)
(6)
b) The Y parameters of a two port network areY6=
3U' Ytz = -llJ'Yzt = -LU
andY22 = ZlJ.Determine the equivalent T-network'

Page 4 of4

Downloaded from Ktunotes.in