Scribd
Upload
7 views6 pages

m5 2

Uploaded by

ksrkf4xxhp
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
7 views6 pages

m5 2

Uploaded by

ksrkf4xxhp
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

M5

08 06 2023

Follow your book to confirm these MCQs.

We are not responsible for your Mistake.

This is for help Only!

• In the normal mode in flight only the primary engine perimeters are
displayed. the *lower display* unit extreme remaining blank.

• Convert

(B)¹⁶ > Octal?

• Base of hexa decimal number is *16*

• *Accuracy* indicates how close the measured value is to the true value

• *Resolution* is a measure of ability to respond to small change in the


input.

• The signal needs to be sampled at a frequency of at least *twice* the


signals bandwidth
• At one point the counter output will after analogue conversion be equal to
the analogue input *so the counter will stop*.

• ARINC 429 Data on this bus are transmitted at a bit rate of *12.5 or 100*
bits per second.

• ARINC 429 data or transferred in *32-bit* words.

• ARINC 429 USES ODD PARITY BIT NUMBER *32* IS USED FOR THIS
PURPOSE.

• *IN NORMAL RECEIVE MODE.*

The current mode coupler receives the voltage signals from the SIM over
the transmit stub cable.

• Question About OR Gate

If One Input is 1 and other is 0, Output will be ?

• A group of eight bits operated on as a unit is referred to as a *byte.*


• Fiber optic signal transmissions depends on the phenomena called *total
internal reflection.*

• *Opto electronic* device that can show alternative characters and other
images

• *Resolution* is the numbers of pixels on the screen.

• *Type 2* transparent static Dissipative

electronics are sensitive to master and are usually packed in this types of
bags. *Type 1*

• Database updates such as navigation database entering data base must


be acquired from a source that is acceptable to the *target hardware
manufacturer*
• Electric fields are produced by *voltages* magnetic fields are produced by
*currents*

• Adverse effects of the electromagnetic environment called


*electromagnetic interference*

• The third harmonic of the fundamental frequency 100 MHz that is


*300MHz.*

• Flight phase related mode in normal operation the *automatic flight phase
related mode* is used.

• In ECAM level 3 is *warning*

• CLR SWITCH LIGHT ILLUMINATE *WHITE* WHENEVER A WARNING ON


STATUS MESSAGE IS DISPLAYED ON THE LEFT HAND DISPLAY UNIT.

• *EADI* displays traditional attitude information pitch and roll


• IN *FLY BY WIRE SYSTEM,*

IS ONE THAT CARRIES CONTROL SURFACES COMMAND FROM THE


FLIGHT CREW INPUT TO POWERED FLIGHT CONTROL SURFACES VIA
ELECTRICAL WIRING.

• In FMC this data is updated periodically every *28 days*

• In FMS storage of aerodynamic and engine data with provisions for


routine updating of the navigation database on *28th cycle*

• The *control and display unit* is the interface between the pilot and the
flight management computer

• *GPS* is a space based radio navigation system which provides


worldwide highly accurate three dimensional position velocity and time
information

• The *monitor stations* are located to provide continuous ground visibility


of every satellite
• The 2 accelerometers are mounted in the system in INS operation.

• TCAS provides *no protection* against aircraft that do not have an


operating transponder

• The range of TCAS is about *30 nautical miles* in the forward direction.

• INdent PUSH BUTTON *WHEN PUSHED CAUSES THAT TRANSPONDER


TO TRANSMIT A SPECIAL IDENTIFIER FALSE SPI IN ITS REPLIES TO THE
GROUND.*

You might also like