Scribd
Upload
6 views2 pages

Mca 04

Uploaded by

contactme.sajib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views2 pages

Mca 04

Uploaded by

contactme.sajib
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

‭Objective:‬‭To develop a program for multiple LED blinking‬‭systems‬

‭Equipment:‬‭Resistor,Battery, Crystal, Capacitor, LED‬‭Light, Microcontroller‬


‭PIC16F877A,‬‭MikroC IDE, Proteus 8 Professional Simulator‬‭Software.‬

‭Working Procedure:‬
‭ . At first create a folder for the program and there will be saved the HEX file.‬
1
‭2. Then open a new project on MikroC‬
‭3. Leave the project type by default.‬
‭4.‬ ‭In‬‭Project‬ ‭Settings‬‭at‬ ‭project‬‭folder‬‭fields.‬‭Select‬‭the‬‭Folder‬‭which‬‭is‬‭created‬
‭for the HEX file. At device name fields. Select PIC16F877A Device.‬
‭5. In the last dialogue box click on ‘finished’.‬
‭6. Now run the specific program for the circuit. After running the program.If you‬
‭saw the ‘finished Successfully’ message.Then the program Executed‬
‭Successfully.‬
‭7. After that go to ‘Proteus 8 professional’ for Circuit Design.‬
‭8. Open ‘proteus 8 professional’ run as administrator.‬
‭9. Then give a project name and path will be set by default.‬
‭10. Click on ‘next’ three times. At last press on ‘finished’.Now start designing‬
‭circuit diagrams on ‘proteus 8 professional’ software. If the circuit design is‬
‭completed,run the simulation.‬
‭Below are the pictures of the steps:‬

‭Figure of Program on MikroC & It Executed Successfully‬


‭Circuit Diagram and It Simulated Successfully‬

You might also like