i.

A transient with a primary frequency component less than 5 kHz, and a duration
from
0.3 to 50ms, is considered a ----------------------------------
a) High frequency transient b) low frequency transient
b) Medium frequency transient d) pulse width
ii. Oscillatory transients with principal frequencies less than --------- can also be
found
on the distribution system.
a) 50Hz b) 100Hz c) 150Hz d) 300Hz
iii. Long-duration variations encompass root-mean square (rms) deviations at power
frequencies for longer than ------------
a) 1min b) 2min c) 3min d) 5min
iv. An ------------is an increase in the rms ac voltage greater than 110 percent at the
power frequency for a duration longer than 1 min.
a) Under voltage b) Over voltage c) Flicker d) None
v. ------------- are used to provide reactive power to correct the power factor, which
reduces losses and supports the voltage on the system.
a)circuit breakers b) fuses c) capacitors d) surge arresters
vi. Newer high – energy MOV arresters for low voltage applications can withstand -
------
a) 2 to 4 kJ b) 400kJ c) 500kJ d) 600kJ
vii. The initial transient frequency is above 1.0 kHz and appears as a small amount
of -------
--------- on the front of the waveform.
a) hash b)flash c)dash d)crash
viii. The main function of surge arresters and TVSS is to limit the -----------------------
that
can appear between two points in the circuit.
a) Power b) voltage c) current d) frequency
ix. ------------------------ are normally open devices that conduct current during over
voltage transients.

a) bar-bar b) vov-bar c) crow bar d)screw-bar

x. An isolation transformer used to attenuate ----------------------------
a) High frequency b) transients stability c) Normal current d) high frequency noise
and
transients
xi. ------------------combines two surge suppressors and a low pass filter to prove
maximum protection.
a) Normal protector b) hybrid protector c) Liquid protector d) line projector
xii. ----------------------------- can reduce the capacitor switching transients.
a) Linear resistors b) Carbon resistors c) Pre-insertion resistors d) Transistors
i. Electric power quality refers to
a) Maintaining near sinusoidal voltage
b) Maintaining near non-sinusoidal voltage
c) Maintaining near non-sinusoidal current
d) None of these
ii. Which of the following are the potential sources of harmonic frequencies?
a) Non-transposed electrical transmission mission
b) Blown out fuse in one phase
c) Severe voltage unbalance
d) All of these
iii. Form factor is
a) Average value/RMS value
b) RMS value/Average value
c) RMS value/RMS value
d) None of these
iv. Which of the following are the effects of harmonics
a) Resonance
b) Poor damping
c) Capacitor bank switching
d) All of these
v. Sag is reduction in RMS voltage within
a) 0.1-0.9 pu b) 0.2-0.4pv c) 0.1-1.11 pu d) none of these
vi. Swell is reduction in RMS voltage within
a) 1.1-1.8 pu b) 1.2-1.4pv c) 1.1-1.11 pu d) none of these
vii. What is power quality?
a) The quantity of electricity consumed
b) The measure of voltage and current consistency
c) The amount of power generated by a source
d) The efficiency of power transmission
viii. Which of the following is NOT a common power quality issue?
a) Voltage sags
b) Harmonics
c) Overvoltage
d) Steady voltage output
ix. What are FACTS (Flexible Alternating Current Transmission Systems)
primarily used
for?
a) Generating electricity
b) Power distribution
c) Power quality improvement and control
d) Energy storage
x. Which of the following FACTS devices is used for controlling the power flow in
transmission lines by varying the line reactance?
a) SVC (Static Var Compensator)
b) TCSC (Thyristor-Controlled Series Capacitor)
c) STATCOM (Static Synchronous Compensator)
d) SSSC (Static Synchronous Series Compensator)
xi. What is deregulation in the context of the power industry?
a) Government control over electricity pricing
b) Removal of government monopoly on power generation and distribution
c) Strict regulations on power plant emissions
d) Privatization of power transmission lines
xii. Which of the following is a potential benefit of deregulation in the power
industry?
a) Decreased competition
b) Higher prices for consumers
c) Increased innovation and efficiency
d) More government intervention
i. A transient with a primary frequency component less than 5 kHz, and a duration
from
0.3 to 50ms, is considered a ----------------------------------
a) High frequency transient b) low frequency transient
b) Medium frequency transient d) pulse width
ii. Oscillatory transients with principal frequencies less than --------- can also be
found
on the distribution system.
a) 50Hz b) 100Hz c) 150Hz d) 300Hz
iii. Long-duration variations encompass root-mean square (rms) deviations at power
frequencies for longer than ------------
a) 1min b) 2min c) 3min d) 5min
iv. An ------------is an increase in the rms ac voltage greater than 110 percent at the
power frequency for a duration longer than 1 min.
a) Under voltage b) Over voltage c) Flicker d) None
v. ------------- are used to provide reactive power to correct the power factor, which
reduces losses and supports the voltage on the system.
a)circuit breakers b) fuses c) capacitors d) surge arresters
vi. Newer high – energy MOV arresters for low voltage applications can withstand -
------
a) 2 to 4 kJ b) 400kJ c) 500kJ d) 600kJ
vii. The initial transient frequency is above 1.0 kHz and appears as a small amount
of -------
--------- on the front of the waveform.
a) hash b)flash c)dash d)crash
viii. The main function of surge arresters and TVSS is to limit the -----------------------
that
can appear between two points in the circuit.
a) Power b) voltage c) current d) frequency
ix. ------------------------ are normally open devices that conduct current during over
voltage transients.

a) bar-bar b) vov-bar c) crow bar d)screw-bar

x. An isolation transformer used to attenuate ----------------------------
a) High frequency b) transients stability c) Normal current d) high frequency noise
and
transients
xi. ------------------combines two surge suppressors and a low pass filter to prove
maximum protection.
a) Normal protector b) hybrid protector c) Liquid protector d) line projector
xii. ----------------------------- can reduce the capacitor switching transients.
a) Linear resistors b) Carbon resistors c) Pre-insertion resistors d) Transistors
i. Electric power quality refers to
a) Maintaining near sinusoidal voltage
b) Maintaining near non-sinusoidal voltage
c) Maintaining near non-sinusoidal current
d) None of these
ii. Which of the following are the potential sources of harmonic frequencies?
a) Non-transposed electrical transmission mission
b) Blown out fuse in one phase
c) Severe voltage unbalance
d) All of these
iii. Form factor is
a) Average value/RMS value
b) RMS value/Average value
c) RMS value/RMS value
d) None of these
iv. Which of the following are the effects of harmonics
a) Resonance
b) Poor damping
c) Capacitor bank switching
d) All of these
v. Sag is reduction in RMS voltage within
a) 0.1-0.9 pu b) 0.2-0.4pv c) 0.1-1.11 pu d) none of these
vi. Swell is reduction in RMS voltage within
a) 1.1-1.8 pu b) 1.2-1.4pv c) 1.1-1.11 pu d) none of these
vii. What is power quality?
a) The quantity of electricity consumed
b) The measure of voltage and current consistency
c) The amount of power generated by a source
d) The efficiency of power transmission
viii. Which of the following is NOT a common power quality issue?
a) Voltage sags
b) Harmonics
c) Overvoltage
d) Steady voltage output
ix. What are FACTS (Flexible Alternating Current Transmission Systems)
primarily used
for?
a) Generating electricity
b) Power distribution
c) Power quality improvement and control
d) Energy storage
x. Which of the following FACTS devices is used for controlling the power flow in
transmission lines by varying the line reactance?
a) SVC (Static Var Compensator)
b) TCSC (Thyristor-Controlled Series Capacitor)
c) STATCOM (Static Synchronous Compensator)
d) SSSC (Static Synchronous Series Compensator)
xi. What is deregulation in the context of the power industry?
a) Government control over electricity pricing
b) Removal of government monopoly on power generation and distribution
c) Strict regulations on power plant emissions
d) Privatization of power transmission lines
xii. Which of the following is a potential benefit of deregulation in the power
industry?
a) Decreased competition
b) Higher prices for consumers
c) Increased innovation and efficiency
d) More government intervention
i. A transient with a primary frequency component less than 5 kHz, and a duration
from
0.3 to 50ms, is considered a ----------------------------------
a) High frequency transient b) low frequency transient
b) Medium frequency transient d) pulse width
ii. Oscillatory transients with principal frequencies less than --------- can also be
found
on the distribution system.
a) 50Hz b) 100Hz c) 150Hz d) 300Hz
iii. Long-duration variations encompass root-mean square (rms) deviations at power
frequencies for longer than ------------
a) 1min b) 2min c) 3min d) 5min
iv. An ------------is an increase in the rms ac voltage greater than 110 percent at the
power frequency for a duration longer than 1 min.
a) Under voltage b) Over voltage c) Flicker d) None
v. ------------- are used to provide reactive power to correct the power factor, which
reduces losses and supports the voltage on the system.
a)circuit breakers b) fuses c) capacitors d) surge arresters
vi. Newer high – energy MOV arresters for low voltage applications can withstand -
------
a) 2 to 4 kJ b) 400kJ c) 500kJ d) 600kJ
vii. The initial transient frequency is above 1.0 kHz and appears as a small amount
of -------
--------- on the front of the waveform.
a) hash b)flash c)dash d)crash
viii. The main function of surge arresters and TVSS is to limit the -----------------------
that
can appear between two points in the circuit.
a) Power b) voltage c) current d) frequency
ix. ------------------------ are normally open devices that conduct current during over
voltage transients.

a) bar-bar b) vov-bar c) crow bar d)screw-bar

x. An isolation transformer used to attenuate ----------------------------
a) High frequency b) transients stability c) Normal current d) high frequency noise
and
transients
xi. ------------------combines two surge suppressors and a low pass filter to prove
maximum protection.
a) Normal protector b) hybrid protector c) Liquid protector d) line projector
xii. ----------------------------- can reduce the capacitor switching transients.
a) Linear resistors b) Carbon resistors c) Pre-insertion resistors d) Transistors
i. Electric power quality refers to
a) Maintaining near sinusoidal voltage
b) Maintaining near non-sinusoidal voltage
c) Maintaining near non-sinusoidal current
d) None of these
ii. Which of the following are the potential sources of harmonic frequencies?
a) Non-transposed electrical transmission mission
b) Blown out fuse in one phase
c) Severe voltage unbalance
d) All of these
iii. Form factor is
a) Average value/RMS value
b) RMS value/Average value
c) RMS value/RMS value
d) None of these
iv. Which of the following are the effects of harmonics
a) Resonance
b) Poor damping
c) Capacitor bank switching
d) All of these
v. Sag is reduction in RMS voltage within
a) 0.1-0.9 pu b) 0.2-0.4pv c) 0.1-1.11 pu d) none of these
vi. Swell is reduction in RMS voltage within
a) 1.1-1.8 pu b) 1.2-1.4pv c) 1.1-1.11 pu d) none of these
vii. What is power quality?
a) The quantity of electricity consumed
b) The measure of voltage and current consistency
c) The amount of power generated by a source
d) The efficiency of power transmission
viii. Which of the following is NOT a common power quality issue?
a) Voltage sags
b) Harmonics
c) Overvoltage
d) Steady voltage output
ix. What are FACTS (Flexible Alternating Current Transmission Systems)
primarily used
for?
a) Generating electricity
b) Power distribution
c) Power quality improvement and control
d) Energy storage
x. Which of the following FACTS devices is used for controlling the power flow in
transmission lines by varying the line reactance?
a) SVC (Static Var Compensator)
b) TCSC (Thyristor-Controlled Series Capacitor)
c) STATCOM (Static Synchronous Compensator)
d) SSSC (Static Synchronous Series Compensator)
xi. What is deregulation in the context of the power industry?
a) Government control over electricity pricing
b) Removal of government monopoly on power generation and distribution
c) Strict regulations on power plant emissions
d) Privatization of power transmission lines
xii. Which of the following is a potential benefit of deregulation in the power
industry?
a) Decreased competition
b) Higher prices for consumers
c) Increased innovation and efficiency
d) More government intervention