Accessory Application Publications No.

AII 33893
INSTALLATION AUTOMATIC DAY/NIGHT 2007 CIVIC
MIRROR WITH COMPASS 4-DOOR Si Issue Date
INSTRUCTIONS OCT 2006

PARTS LIST TOOLS AND SUPPLIES REQUIRED

Phillips screwdriver
Automatic Day/Night Mirror With Compass
P/N 08V03-SDA-100B Flat-tip screwdriver
T25 TORX bit
Day/Night mirror Ratchet
10 mm Socket
Isopropyl alcohol
Shop towel
Piece of steel wire
Spring
Tape
Long nose pliers
Small rubber mallet
Tape measure
Owner’s Manual
Illustration of the Day/Night Mirror Installed on
the Vehicle

Automatic Day/Night Mirror Attachment Kit

P/N 08V03-SNA-100
DAY/NIGHT
MIRROR
Upper and lower covers HARNESS DAY/NIGHT
MIRROR

Day/night mirror harness

FUSE CASE
8 Wire ties (1A) 5217011T

5 EPT sealers

Clip

© 2006 American Honda Motor Co., Inc. - All Rights Reserved. AII 33893 (0610) 08V03-SNA-1000-91 1 of 8
 INSTALLATION Other Vehicles
Customer Information: The information in this
• Remove the two bolts, and unplug the vehicle
installation instruction is intended for use only by
connector(s).
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
VEHICLE
equipment to your vehicle. These procedures CONNECTOR
should not be attempted by “do-it-yourselfers.” (If equipped)
VEHICLE
CONNECTOR
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the FRONT
preset buttons.
MAP LIGHT
CONSOLE
2. Disconnect the negative cable from the battery.
3. If equipped with a map light console, use a small
flat-tip screwdriver to remove the left and right
lens from the map light console. (four retaining
tabs for each lens). Remove the map light
console:
RETAINING LENS
TABS (4)
• Remove the two bolts, and unplug the vehicle
3-pin connector. Then remove the switch (four
retaining tabs and unplug the two vehicle BOLT
connectors).
LENS
With Moonroof and Navigation System 5202590T

VEHICLE 4. Remove the sunvisor holders. Using a flat-tip

CONNECTOR
VEHICLE 3-PIN screwdriver, push the hook, turn the holder 90°,
CONNECTOR then pull it out.
FRONT

RETAINING
TABS (4)

MAP LIGHT LENS

CONSOLE
BOLTS (2)

RETAINING
TABS (4)
LENS
SWITCH 5202600T

SUNVISOR
HOLDER FLAT-TIP
SCREWDRIVER 5217020T

2 of 8 AII 33893 (0610) © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
 5. Remove the cap from the left sunvisor (four 9. Pull away the weatherstrip from the left front pillar
retaining tabs). trim.

Strike perpendicularly
CONNECTOR to the vehicle.

RETAINING
TABS (4) FRONT PILLAR

PIN

FRONT CLIP
LEFT PILLAR TRIM
CAP SUNVISOR
TORX SCREW
5217030T
SHOP
TOWEL
6. Remove the left sunvisor (two T25 TORX screws,
RUBBER
and unplug the vehicle connectors). MALLET

7. Repeat steps 5 and 6 to remove the right

STRIKE POINT
sunvisor.
8. Remove the rearview mirror from the holder by CLIP
5217160T

rotating the stay 90° clockwise.

WEATHERSTRIP LEFT FRONT
PILLAR TRIM
Rotate 90°
STAY clockwise.
10. Use a small rubber mallet and a shop towel to
release the clip on the left front pillar trim.
MIRROR
HOLDER
Tap the trim just under the "SIDE CURTAIN
AIRBAG" marking.
11. Pull away the weatherstrip from the left front pillar
trim. Remove the left front pillar trim (two clips).

LEFT FRONT
PILLAR TRIM CLIPS (2)

REARVIEW
MIRROR
2304041M

5202101T
WEATHERSTRIP

© 2006 American Honda Motor Co., Inc. - All Rights Reserved. AII 33893 (0610) 3 of 8
 12. Remove the clip from the left front pillar trim. 16. If equipped, remove the driver’s dashboard under
cover (turn the knob 90° counterclockwise, and
release two clips and pin).
NEW CLIP
PIN

CLIP (Discard.)

LEFT FRONT
PILLAR TRIM

5217110T

13. Install a new clip on the left front pillar trim. CLIP (2) DRIVER’S
DASHBOARD KNOB
14. Lower the left front grab rail and remove the two UNDER COVER
caps using a flat-tip screwdriver.
5202112T

CLIPS (2)
17. Remove the driver’s dashboard lower cover (eight
clips).

CAPS (2)

LEFT FRONT
GRAB RAIL
FRONT

DRIVER’S DASHBOARD
5202280T LOWER COVER

CLIPS (8) 5202121T

15. Using a flat-tip screwdriver, remove the grab rail
from its two clips.

4 of 8 AII 33893 (0610) © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
 18. Replace the spring. Slide the day/night mirror stay 20. Tape a piece of steel wire to the 7-pin connector
onto the mirror holder, then turn the mirror end of the day/night mirror harness. Pull the 7-pin
counterclockwise as shown. connector up and out through the clearance
between the left front pillar and the instrument
panel.
VEHICLE SPRING
(Discard.) MIRROR HOLDER

DAY/NIGHT
MIRROR
LEFT
HARNESS
FRONT 7-PIN
PILLAR
CONNECTOR
SPRING

Turn the mirror stay

counterclockwise. MIRROR
HOLDER

STEEL
WIRE INSTRUMENT
PANEL
MIRROR DAY/NIGHT
STAY MIRROR HARNESS
7-PIN CONNECTOR
TAPE

DAY/NIGHT 5217051T
MIRROR

2304051M 21. Remove the tape and the steel wire from the day/
night mirror harness.
19. Wrap one EPT sealer around the day/night mirror 22. Continue routing the day/night mirror harness
harness at the location shown. 7-pin connector up along the vehicle harness,
and out from behind the roof liner near the mirror.
100 mm
EPT SEALER
DAY/NIGHT
MIRROR
ROOF HARNESS
LINER

DAY/NIGHT MIRROR
DAY/NIGHT 5217120T HARNESS 7-PIN
MIRROR CONNECTOR
HARNESS GREEN
TAPE VEHICLE
HARNESS 5217061T

WIRE TIE

23. Secure the day/night mirror harness to the vehicle

harness with one wire tie at the green tape.

© 2006 American Honda Motor Co., Inc. - All Rights Reserved. AII 33893 (0610) 5 of 8
 24. Plug the day/night mirror harness 7-pin connector 27. Using isopropyl alcohol on a shop towel, clean the
into the rear of the mirror. areas where the EPT sealer will attach. Under the
roof liner, secure the day/night mirror harness to
the roof panel with the four EPT sealers in the
DAY/NIGHT
MIRROR areas shown.
HARNESS
7-PIN
CONNECTOR EPT SEALER ROOF
LINER

ROOF
DAY/NIGHT PANEL
5217041T MIRROR
HARNESS
DAY/NIGHT
MIRROR

5217072T
25. Measure the day/night mirror harness in the area
shown. Route the day/night mirror harness through
the grooves in the upper and lower covers. Attach 28. Secure the day/night mirror harness to the vehicle
the lower cover to the mirror stay. harness with three wire ties in the areas shown.

LOWER
COVER WIRE
ROOF VEHICLE
HARNESS TIES
LINER DAY/NIGHT (3)
MIRROR
HARNESS

DAY/NIGHT
MIRROR STAY
DAY/NIGHT
200 mm MIRROR
UPPER HARNESS
AND
LOWER
COVERS DAY/NIGHT
MIRROR
5217081T

5217140T

26. Slide the upper cover up under the roof liner.

6 of 8 AII 33893 (0610) © 2006 American Honda Motor Co., Inc. - All Rights Reserved.
 29. Plug the day/night mirror harness 6-pin connector 30. Remove the ground bolt from the vehicle bracket.
into the 6-pin connector at the fuse box. Secure the day/night mirror harness ground
terminal with the ground bolt you just removed.

VEHICLE
BRACKET

FUSE BOX GROUND

6-PIN TERMINAL
CONNECTOR
FUSE GROUND
BOX BOLT
(Reuse.)

FRONT
DAY/NIGHT
MIRROR DAY/NIGHT
HARNESS MIRROR
DAY/NIGHT 6-PIN HARNESS
MIRROR CONNECTOR
HARNESS
FUSE 5217152T 5217132T
BOX

31. Secure the day/night mirror harness to the vehicle

NOTE: If another accessory is already plugged
harness with four wire ties in the areas shown.
into the 6-pin connector, remove the dummy
connector from the 6-pin connector taped to the
day/night mirror harness. Disconnect the 6-pin
connector of the other accessory harness from the
fuse box and connect it to this 6-pin connector.

DAY/NIGHT
MIRROR
HARNESS 6-PIN
CONNECTOR

FUSE BOX

WIRE
TIES (4)
DUMMY
CONNECTOR VEHICLE
(Discard.) HARNESS
FUSE
BOX
OTHER ACCESSORY
HARNESS 6-PIN
CONNECTOR
5217094T

5213100T DAY/NIGHT
MIRROR
HARNESS

© 2006 American Honda Motor Co., Inc. - All Rights Reserved. AII 33893 (0610) 7 of 8
 32. Check that all wire harnesses are routed properly
and all connectors are plugged in.
33. Reinstall the grab rail; remove the two clips from
the vehicle. After installing the clips and caps on
the grab rail, reinstall the grab rail on the vehicle.

CAP

CLIPS (2)

VEHICLE FRONT
PANEL
LEFT FRONT
GRAB RAIL

5308590T
SECTIONAL VIEW

34. Reinstall all removed parts. Check that all clips

and other fasteners are installed securely. Take
care not to pinch the airbag with a clip during
reinstallation of the front pillar trim. Do not push
the front pillar trim excessively.
35. Reconnect the negative cable to the battery.
36. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
37. Reset the clock.
38. Check the operation of the automatic day/night
mirror according to the Owner’s Manual supplied.
NOTE: When the battery is disconnected, the driver’s
window AUTO function is disabled.
• Start the engine. Push down on the driver’s
window switch until the window is fully open.
• Pull up on the driver’s window switch to close the
window completely, then hold the switch for
2 seconds or more.
• Lower and raise the driver’s window to check
operation of the driver’s window AUTO function.

8 of 8 AII 33893 (0610) © 2006 American Honda Motor Co., Inc. - All Rights Reserved.