Scribd
Upload
34 views

Assignment # 01

Uploaded by

70135185
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Assignment # 01

Uploaded by

70135185
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Continued From Overleaf 2

Total Pages

THE UNIVERSITY OF LAHORE


Faculty of Engineering & Technology
Mechanical Engineering Department
Fall Semester 2024
Numerical Problems (NP’s)
Introduction to Finite Element
Instructor’s Name: Muhammad Usman Assignment-1: Analysis

Date: 08-11-2024 Subject Code: ME03454

Time Allowed: N/A Total Marks: 10

Instructions for Candidates


i. Read the instructions on NPs carefully.
ii. Fill in the details required on Answer-book.
iii. Each question must be answered and completed.
iv. Attempt all questions.
v. Any question not attempted will be marked as incorrect.
vi. Solve the problems using all the steps along with properly labeled FBD’s.
vii. All questions carry equal marks.
viii. Cross off blank pages before handing over Answer-book to the examination staff at completion of this section of
the examination.
Local & Global Co-Ordinate Transformation
[CLO1 | C2 | PLO1] [10]

Q1. Determine the coordinates of point A if the local coordinate system is rotated 15
degrees relative to the global coordinate system. The global coordinates of point A are
(30,50).

Page 1 of 2
Please turn over
Continued From Overleaf

Q2. Determine the global coordinates of point B if the local coordinate system is rotated 30
degrees relative to the global coordinate system. The local coordinates of point B are
(30,15).

Q3. Given: two-dimensional truss structure as shown. Material: Steel, diameter ¼ in. Find:
(a) Displacements of the nodes.
(b) Normal stresses developed in the members.

Q4. Given: Two-dimensional truss structure as shown (All joints are pin joint). Find
(a) Displacements of the nodes.
(b) Normal stresses developed in the members.

Page 2 of 2
Please turn over

You might also like