Scribd
Upload
5 views

Tutorial 3-1

Uploaded by

Candy 49
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
5 views

Tutorial 3-1

Uploaded by

Candy 49
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Siddaganga Institute of Technology

Department of Electrical & Electronics Engineering


Power Systems – III [7REE01]
Tutorial 3

1. For the power system shown in figure with Bus 1 as reference and line data impedances in PU as
shown. Compute Zbus using building algorithm. Add the elements in sequence 1-2, 2-3 and 1-3.

2. Form ZBUS by building algorithms analysis as per the data in the table shown below. Add elements in
the sequence 0-2, 0-3, 0-4, 1-4 and 2-5. Select node-0 as the reference node.
Bus Code (p - q) 0 - 2 0 - 3 0 - 4 1 - 4 2 - 5
PU imp. Zpq - pq 0.3 0.2 0.4 0.1 0.5
3. Obtain the bus impedance matrix of the power system network shown in figure. Take reactance of
each line as j0.3 p. u.

4. If the line L2 between the buses 1 and 2 is removed from figure of example 3, modify the ZBus.

5. Determine bus impedance matrix for the network shown in Fig., where the impedances are in per unit.
Preserve all three nodes. Use Zbus building algorithm.

You might also like