Hill Acme: Detail B Scale 1: 1

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

8 7 6 5 4 3 2 1

REVISIONS
REV DESCRIPTION DATE INITIALS
- INITIAL RELEASE 120621 AD

.002 A
D D
5.250
.25 5.248
A
A 32
B

R.50
R.50
C C
.906
R2.813 .002 A

9.750
9.748 .748
.13 .746
.03 X 45°
0.01" THICK R2.913
#21 STELLITE

32
WELD .03

B DETAIL B B
STAMP SCALE 1 : 1
PART NO. AND
BALL SIZE

10.00
A .06 X 45° .03 X 45° .03 X 45°

PROCESURE TO COATING WELD WITH STELLITE 21; SECTION A-A


1. BEFORE TO COATING WITH WELD, MUST HEAT THE BASE MATERIAL IN AN OVEN TO 500 C. 63
2. MAKE COATING WELD, TAKING INTO ACCOUNT THAT YOU SHOULD NOT CROSS THE ( )
INTERFACE TEMPERATURE OF 600 C.
A 3. IF NECESSARY INTERRUPT THE WELDING PROCESS, THE MATRIX MUST BE COVERED WITH A
CERAMIC BLANKET (OR SIMLAR) TO PREVENT QUENCHING. THIS DESIGN IS PROPERTY OF HILL ACME Material

HILL ACME
Approved/Released

4. AFER OF FINISHING THE PROCESS OF COATING WELD, MATRIX COOL SLOWLY IN A BOX AND IS LOANED ONLY UPON THE CONDITION
THAT IT IS NOT TO BE COPIED OR REPRODUCED,
STEEL, AISI 4340, FORGED
WITH SAND OR DRY LIME UNTIL REACHING ROOM TEMPERATURE. NOR TO BE USED FOR ANY PURPOSE DETRIMENTAL
TO THE INTERESTS OF HILL ACME.
Drawn By
a division of MAGNUM INTEGRATED TECHNOLOGIES ADUNEVEIN
Date
12/06/2021
5. NOW CAN BE MACHINED THE COATING WELD, IT IS POSSIBLE THAT IN COATING WELD PROJECTION UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES
Brampton, Ontario Canada Size Scale Checked Weight
APPEAR CRACKS, BUT ARE TYPICAL TO THE PROCESS AND WELDING, DUE TO THE MACHINING TOLERANCES: B 1:2 SK 99.8 lb
CHROMIUM CARBIDE ALLOY IN A COBALT MATRIX. THIRD ANGLE
X/X = 1/64 X = 1
X.XX = 0.010 X.XXX = 0.003
DIE INSERT FOR 5.5" BALL Drawing No. Sheet Rev.
DEBURR ALL
SHARP EDGES
DO NOT SCALE DRAWING
MOL
TOOLING ASSEMBLY 61BF-A16343-5 1 of 1 -
8 7 6 5 4 3 2 1

You might also like