Scribd Logo
Upload

Welcome to Scribd!

  • 9 views

    Clutch

    Uploaded by

    rishita.tiwari.cd.mec21

    Copyright:

    © All Rights Reserved
    Download as DOC, PDF, TXT or read online from Scribd

    Clutch

    Uploaded by

    rishita.tiwari.cd.mec21
    9 views1 page

    Copyright

    © © All Rights Reserved

    Available Formats

    DOC, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as DOC, PDF, TXT or read online from Scribd
    Download as doc, pdf, or txt
    9 views1 page

    Clutch

    Uploaded by

    rishita.tiwari.cd.mec21

    Copyright:

    © All Rights Reserved
    Download as DOC, PDF, TXT or read online from Scribd
    Download as doc, pdf, or txt
    of 1

    ME-311, Fundamentals of Machine Design

    B.Tech. / M.Tech (Dual Degree) Part III, (V Semester), 2024


    Practice Assignment Sheet
    Design of Clutch

    1. A single plate friction clutch of both sides effectively has a 300 mm


    outer diameter and 160 mm inner diameter. The coefficient of
    friction is 0.2, and it runs at 1000 rpm. Find the power transmitted
    for uniform wear and uniform pressure distribution cases if the
    allowable maximum pressure is 0.08 MPa.

    2. A multi-plate clutch of alternate bronze and steel plates is to


    transmit 6 kW power at 800 rpm. The inner radius is 38 mm, and the
    outer radius is 70 mm. The coefficient of friction is 0.1, and the
    maximum allowable pressure is 350 kPa. Determine (i) the Axial
    force required, (ii) the Total number of discs, (iii) the Average
    pressure, and (iv) the Actual maximum pressure

    3. A Multiple plate clutch has steel on bronze to transmit 8 KW at 1440


    rpm. The inner diameter of the contact is 80mm, and the outer
    diameter of the contact is 140 mm. The clutch operates in oil with a
    coefficient of friction of 0.1. The overage allowable pressure is
    0.35MPa. Assume uniform wear theory and determine the following.
    a) Number of steel and bronze plates b) Axial force required c)
    Actual maximum pressure

    4. A cone clutch is to transmit 7.5 KW at 600 rpm. The face width is 50


    mm, the mean diameter is 300 mm and the face angle is 15°.
    Assuming the coefficient of friction is 0.2, determine the axial force
    necessary to hold the clutch parts together and the normal pressure
    on the cone surface.

    5. A friction cone clutch has to transmit a torque of 200 N-m at 1440


    rpm. The longer diameter of the cone is 350mm. The cone pitch
    angle is 6.25 °, the force width is 65 mm, and the coefficient of
    friction is 0.2. Determine i) the axial force required to transmit the
    torque. ii) The average normal pressure on the contact surface when
    maximum torque is transmitted.

    You might also like