BD/GPS Tracker Terminal

Quick

Installation

User
Manual
(Version V2.1)

Thank you very much for using GPS TRACKER, the user manual will guide how to operate this
product, please read it carefully before using it in order to get the correct method of operation. If
the appearance, color and accessories of this product are modified, please refer to the actual
product. The manufacturer is not liable for faults and omissions which in the user manual.

1、Product functions & Parameters

1.1 Product functions
Location inquiry, geo-fence, power-off alarm, vibration alarm, movement alarm, over-speed
alarm, historical route playback, parking report, remote power/oil off.

1.2 Parameters
●QUECTEL EC20 module (different modules for different countries, the following are the
frequency bands for EC20, different countries with different modules and frequency)
4G:LTE FDD:B1/B3/B5/B8
LTE TDD：B34/B38/B39/B40/B41
3G :WCDMA:B1/B8
 :TD-SCDMA:B34/B39
2G :CDMA:BC0 900/1800MHz
●Wide voltage input range: 9 - 75V;
●Location time: average warm start:≤3sec(open sky)
Average cold start:≤35sec(open sky)
●Device dimensions:99mm × 52mm × 17mm;
●Location accuracy:≤10 meters;
●Working Temp:-20℃ - 75℃

PLEASE NOTE: Install and use this product under the voltage input range, if illegal installation,
the user should take the responsibility themselves if any damage happened!

2、Product accessories and LED light status

2.1 Product accessories:
Standard: the device/ charging cable / quick installation user manual / double-sided stickers
Optional: micro-phone, SOS button, relay

2.2 Device LED light status

2.2.1 Red LED (Power supply/working)
Light status Meaning
light Working normal
off Power off
2.2.2 Yellow LED (GSM signal)
Light status Meaning
Quick flash 1 time within 2 seconds GSM initialization
light GPRS normal communication/online
off GSM sleep/power off
2.2.3 Blue LED (GPS signal)
Light status Meaning
Quick flash 1 time within 2 seconds GPS signal searching
light GPS location finished
off GPS sleep/power off

3、Installation instructions
3.1 Preparation before installation:
1, Open the box and check whether the device and the accessories are complete, otherwise
please contact your dealer.
2, SIM card selection, the device works with standard SIM card, and support full Netcom
band.
3, SIM card installation, there is a small back cover on one side of the terminal, push out the
small back cover, pick up the metal cover of the SIM card slot, put the SIM card chip down into
the card slot, and cover the metal cover of the card slot.
Note: (1) Before installing or removing the SIM card, please switch off the device;
(2) Should activate the GPRS function of the SIM card;
(3) Should activate the caller ID function; (activate or not according to the
functions you chose.)
(4) If your SIM card required you to input the SIM PIN, please refer to your
mobile phone user manual to turn off the SIM PIN function.
(5) Please ensure that the SIM card is valid.

3.2 Installation
We recommend a hidden installation, and we suggest that you ask a professional
organization designated by the dealer. Please note the following:
1, Hidden installation, pay attention to waterproof;
2, Do not put together with the launch source, such as reversing radar, anti-theft device or
other in-vehicle communication equipment;
3, GSM antenna and GPRS antenna were built-in the device, make sure that the GPS
receiving surface (GPS antenna surface without label) is upward (toward the sky), and there is
no metal shielding on the top.
Recommended installation location:
(1) Inside the decorative frame under the front windshield of the car;
(2) Areas around the front dashboard of the car (non-metallic material surface);
(3) Under the decorative plate of the rear windshield of the car;
(4) Inside the car door or the middle column;
(5) Inside the instrument panel or under the rear seat of the electric bicycle/motorcycle

4、Wiring precautions
5.1 Please select the harness provided by the original factory. The red line is the positive and
the black is the negative pole of the power supply. When installing the negative pole of
the power supply, please choose to ground or connect metal separately. Do not
connect with other ground wires.
5.2 ACC line (orange line) connected to the vehicle's ACC switch; if ACC auto anti-theft
function is required, make sure to connect the ACC line. The device will enter into the
armed state or not according to ACC status. If the ACC line is not connected, the vehicle
will enter into the armed state. If so, a vibration alarm will be triggered if vibration
when vehicle moving.
5.3 The oil-off control line (yellow line) connected to the thin yellow line of the circuit
breaker.
Proper use of the product: Installation → Switch on → Settings → Register
Installation: When installing, the GPS antenna surface should face the sky. There should be no
electromagnetic wave absorber (such as metal or explosion-proof film).
Switch on: Insert the SIM card with right direction, connect the cable according to the wiring
diagram, and then switch on the device.
Register platform account: The registration method varies according to the dealer's platform,
please consult the dealer.

5、SMS commands and instructions:

Send SMS command from user’s SIM card number to the SIM card number which inside the
GPS device.
The commands in the following SMS command list are in English input format, and the
letters are case-sensitive according to the instruction requirements.
Common inquiry SMS command format Device reply
Center number setting 101#13712345678# OK
Device status query CXZT Version, ID, IP, etc…
Chinese address inquiry 123 Chinese address
Latitude and longitude link query G1234 Google map link
Reset the device CQ system reset OK!
Restart GPS CQGPS GPS reset OK!
Restore factory settings FORMAT OK!
Revise APN apn123456 cmnet apn ok
Revise APN user name apnuser123456 user apnuser ok

Revise APN password apnpasswd123456 password apnpasswd ok

ignition/motion upload freq,123456,20 OK
interval
Flameout upload time interval static,123456,120 OK
setting
Revise Server IP IP+blank+IP+blank+port set IP OK
Example：IP 106.3.230.234 8185

6、App operation
Login location service platform
Users can login to the global positioning service platform provided by the dealer, to check the
location and status of the vehicle, and perform corresponding operations. Please consult your
dealer for the service platform website.

Platform login on computer:

For individual users, please login with the device ID number. The ID number is on the device body
and also on the package box. When logging in to the platform, please select IEIM/License number
to log in. The default password is: 123456
Enterprise users and fleet users please select the username to log in. User name and password
are set by dealer, please contact your dealer for distribution!

Android APP download, please scan the QR code on the computer, and if Apple mobile phone,
please search the APP name in the App store.

7、Trouble shooting
If the device can’t be connected to the background server after first time installation, and the
background server shows it is offline, please check the installation correct or not.
If you have any questions for the operation, please refer to the following questions and
solutions; if you still can't solve the problem, please contact your dealer.
Common Problems Reasons Solutions
Test at areas where there are
high buildings or underground
Weak signal parking lots, where radio Use it at a good signal place
waves cannot be sent or
received normally.
Main power supply connected Do not connect to the main control
correct or not line of the vehicle
platform shows device
SIM inserted not correct Check the SIM card
not activated after first
LED status Check if the indicator is blinking or
installation
steady
SIM without GPRS activated or Please contact carrier to activate
 SIM card out of charge. GPRS or charge
GPS no location Please go to outdoor place where
GPS signal good
Platform map shows
Vehicle did not move after Please drive the vehicle on the
incorrect location
installation road
ACC connected or not Connect the device and turn on
ACC
Platform shows the main Poor power supply connection Check whether the power supply
power disconnect line of the device connected
correct or not
SIM card out of charge of Please check your SIM card
Platform shows device
GPRS was canceled
offline
Weak signal area Please try again at good signal area
 Warranty card

Special statements:
1. If there is any technical modification for this product in the future, no further
notice.
2. If the appearance or color of the product were changed, please refer to real
product.
3. The warranty card is only applicable to product with IMEI number listed as below.
4. Please keep this card in good condition. Please present this card and the original
purchase receipt when you apply warranty.
5. Please refer to the table below for the warranty range.

This card is the basic proof of the warranty. Please fill in the card carefully and
keep it in good condition.
User Name Telephone
Number
Address
Model No. IMEI
Purchasing Commercial
Date invoice No.
Seller Name
Seller Address
Seller contact
number
1. One year from the date of purchase, the non-human damage failure is
guaranteed for one year;
2. Any of the following conditions is not covered by the warranty, but can be
repaired if you pay the cost
(1) Exceeding the warranty period;
(2) Damage caused by unauthorized disassembly or repair without the
authorization of our company;
(3) immersed in water and the circuit board was burnt;
(4) Damage caused by improper installation, use, maintenance or storage;
(5) damage of outer casing caused by the improper use;
(6) The IMEI number of the product is torn or blurred;
(7) The warranty card and product model No. not match, or the warranty card
was altered;
(8) Damage caused by force majeure.