Scribd
Upload
19 views3 pages

Me231 Midterm - Fall (2020-2021) - Example

Uploaded by

mertvemert2828
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
19 views3 pages

Me231 Midterm - Fall (2020-2021) - Example

Uploaded by

mertvemert2828
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Name-Surname : 11 December 2020

Number :
Signiture :

ME231 / Mechanical Engineering Drawing

MIDTERM (Online)

1) (1pt each) Draw any possible TOP views which the


front view may define. (axes lines, if exist, are not
drawn) [parts must be physically consistent (possible
to build) ] (recursivity, if exists, will be graded with 2
points max) [Unclear sketches will be graded null]

2) (10pts) Why do we need different thread profiles?

3) (15pts, 5 each)
a) Why do we need tolerancing?

b) Why do we use standards?

c) How does ISO tolerancing represent a tolerance?

QUESTIONS 1 2 3 4 5 6 7 8
POINTS
10 10 15 10 20 15 10 10
(100)
Sections &

Sections &
Tolerance

Fasteners
Screws &
Sections

Sections
Projecti
Screws

Fasten
3D

Grading :

1
4) (10pts.) Draw a formal Sloped Section for the part in Fig.2, (a vessel with two flanges at each end /
flanşlı boru). Include ALL the necessary information for a section, sketch on views if necessary !

Answer :

Figure.2

5) (20 pts.-10p. each) Assemble the parts below, and take a proper lateral section, passing through the
5/16 dia holes. Draw the top view. Sketch them free hand. Do not use dimensions, just keep the
ratios close to real. Meanwhile, beware of the mechanical components used. (Your drawing must
be CLEAN and COMPLETELY FORMAL)

2
6) (15 pts.) Join any two parts using the fastening components you see below. Take a proper lateral
section of your assembly. Make sure all the necessary details of such an assembly is there and are
all legible. Name and give specifications for the components. (Lengths are not important. Use your
free hand, no rulers ! )

Part 2 Part 1

Part 3

7) (10 pts.) What are the main differences between basic key types; axial tapered, axial non-tapered,
radial, woodroof?

8) (10 pts. each) Find at your environment (home/garage etc.), any two of the fastening elements we
have learned (other then the one in question #6), name them, add their detail picture on your exam
paper and draw their lateral sections as it appears at you.

Good Luck – Dr. Haluk BAYRAKTAR 3

You might also like