Scribd
Upload
17 views3 pages

Tutorial Sheet 6 Sampling

Uploaded by

balharavinay21
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views3 pages

Tutorial Sheet 6 Sampling

Uploaded by

balharavinay21
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

1

ELL 205: Signals & Systems


Tutorial Sheet-6
2024-25

Ques 1: Determine the Nyquist rate corresponding to each of the following signals:

A) x(t) = 1 + cos (2000πt) + sin (4000πt)


sin (4000πt)
B) x(t) =
πt
sin (4000πt) 2
C) x(t) =
πt
Ques 2: Let x(t) be a signal with Nyquist rate ω0 . Determine the Nyquist rate for each of the following
signals:

A) x(t) + x(t − 1)
dx(t)
B) dt

C) x2 (t)

D) x(t) cos ω0t

Ques 3: The output y(t) of the following system is to be sampled, so as to reconstruct it from its samples
uniquely. The required minimum sampling rate is:

Fig. 1

Ques 4: A signal x[n] with Fourier transform X(e jω ) has the property that
π
h ∞ i hsin n i
x[n] ∑ δ[n − 3k] ∗ π 3 = x[n]
k=−∞ n
3
For what values of ω is it guranteed that X(e jω ) = 0?
2

Ques 5: A signal x[n] has a Fourier transform X(e jω ) that is zero for (π/4) ≤ |ω| ≤ π. Another signal
∞
g[n] = x[n] ∑ δ[n − 1 − 4k]
k=−∞

is generated. Specify the frequency response H(e jw ) of a low pass filter that produces x[n] as output when
g[n] is the input.

Ques 6: A signal x p (t) is obtained through impulse-train sampling of a sinusoidal signal x(t) whose
frequency is equal to half the sampling frequency ωs .
ω 
s
x(t) = cos t +φ
2
and
+∞
x p (t) = ∑ x(nT )δ(t − nT )
n=−∞

where T = 2πωs .
(a) Find g(t) such that ω 
s
x(t) = cos(φ) cos t + g(t).
2
(b) Show that
g(nT ) = 0 for n = 0, ±1, ±2, . . .
(c) Using the results of the previous two parts, show that if x p (t) is applied as the input to an ideal
lowpass filter with cutoff frequency ωs /2, the resulting output is
ω 
s
y(t) = cos(φ) cos t .
2

Ques 7: If x[n] = cos π4 n + φ0 with 0 ≤ φ0 < 2π and g[n] = x[n] ∑∞ k=−∞ δ[n − 4k], what additional con-
straints must be imposed on φ0 to ensure that
!
sin π4 n
g[n] ∗ π = x[n].
4n

Ques 8: Consider the two continuous-time signals defined below:


( (
|t|, −1 ≤ t ≤ 1 1 − |t|, −1 ≤ t ≤ 1
x1 (t) = , x2 (t) =
0, otherwise 0, otherwise
These signals are sampled with a sampling period of T = 0.25 seconds to obtain discrete-time signals
x1 [n] and x2 [n], respectively.Show if the energy of x1 [n] is samller than the energy of x2 [n].
Ques 9: The signal x(t) = Sin(14000πt),where t is in second sampled at a rate of 9000 samples per second.
The sampled signal is the input to an ideal low pass filter with frequency response H( f ) as follows:
(
1, | f | ≤ 12KHz
H( f ) =
0, | f | > 12KHz
What is the number of sinusoids in the output and their frequencues in kHz
Ques 10: A digital measuring intrument employs a sampling rate 100 samples/second. The sampled input
3

x[n] is averaged using the difference equation


y[n] = [x[n] + x[n − 1] + x[n − 2] + x[n − 4]]/4
For the step input, the maximum time taken for the output to reach the final value after the input transition
is?
Ques 11: Shown in Figure 2 is a system that processes continuous-time signals using a digital filter h[n]
that is linear and causal with difference equation
1
y[n] = y[n − 1] + x[n]
2
For input signals that are band limited such that Xc ( jω) = 0 for |ω| > πT , the system in the figure is
equivalent to a continuous-time LTI system. Determine the frequency response Hc ( jw) of the equivalent
overall system with input xc (t) and output Yc (t).

Fig. 2

You might also like