Scribd
Upload
16 views2 pages

Compliance Statement - MTS

COMPLIANCE STATEMENT_MTS

Uploaded by

Chris Enyinnaya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
16 views2 pages

Compliance Statement - MTS

COMPLIANCE STATEMENT_MTS

Uploaded by

Chris Enyinnaya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

COMPLIANCE STATEMENT

Specification Comply
Project Specification/QCS 2014 Remarks
Sec. Ref. Yes No N/A
Section 25
Part 02

2.2.4 2.2.4 Mirror Glass Proposed Mirror is
Mirror glass is to be 6 mm float glass or polished plate 6mm thick with silver
glass, silvered on one side. The silvering shall be protective coating.
protected by a copper backing and protective paint

coating. Mirror edges shall be ground and polished.
Mirror edges shall be bevelled.
3.4 3.4 FIXING MIRRORS
3.4.1 General Requirements
Mirrors are to be fixed with spacer washers to Mirrors are to be fixed with spacer
compensate for irregularities in the wall surface and washers to
with sleeves and washers to prevent contact between compensate for
the mirror and the fixings.
 irregularities in the wall surface and with
sleeves and washers to prevent contact
between the mirror and the fixings.
PROJECT SPECIFICATIONS
6mm thick, clear floated , triple-silvered electro-copper plated with Proposed Mirror is
2.2.1 Glass baked enamel backing, conforming to ASTM C1036, 91 or 92  6mm thick with silver
Mirror ( depending on the sizes and requirements) and FS DD-M-411C. protective coating.
2.3.1 Glass Refer to the drawings and ID schedule of the finishes for the mirror Noted and complied
mirror type and type size 
and size
Glazing clip Slotted and 4 screw hole concealed type glazing clips fabricated of Noted and complied.
2.4.1 1.5mm (16 gauge) steel having bright polish chrome plated finish on 
the joint edge and face, acceptable to the Engineer.
2.4.2 Screw and fastenings shall be Grade 316 stainless steel conforming Screw and fastenings shall be Grade 316
to ASTM F593-17  stainless steel conforming to ASTM F593-
17
Mirror Special high quality, petroleum resin, aliphatic solvent and Noted and will comply
Adhesives thickening agent type or rubber based adhesive type mastic, 
2.5.1 suitable for tropical or high humidity condition.
Mirror Special protective coating for back-painting/isolating mirrors, Noted and will comply
backing developed for us with mirror adhesive and suitable for tropical or
protective high humidity conditions.

coating 2.6.1
Mirror Special penetrating type substrate sealer, developed for use with Noted and will comply
substrate mirror adhesive and mirror protective coating, and suitable for 
sealer 2.7.2 tropical or high humidity condition.

You might also like