Torque Calculator
Uploaded by
ochappuiTorque Calculator
Uploaded by
ochappuiCalculation according to DIN946 (Rotzler formula) when using NORD-LOCK washers
Bolt size Thread pitch [mm] B Mean diam. of thread [mm] Load area [mm2] Thread friction OD of contact area [mm] D ID of contact area [mm] E Mean diam. of contact area Washer friction Yield point of bolt [Mpa] G
A M
T C
W F
0.0
0.00
0.00
= specify parameters A B C D E F G H
Bolt grade
Specify bolt size (Metric only) Specify tread pitch Specify thread friction (if possible please use chart 1 below) OD of contactact area = outer diameter of contact area between NL washer and nut/bolt head ID of contactact area = inner diameter of contact area between NL washer and nut/bolt head Specify washer friction (if possible use chart 1 below) Specify yield point of bolt (if possible use chart 2 below) Specify ratio of the bolt's yield point (%)
Non Lubricated Thread Washer With oil spray Thread Washer With MoS2 Thread Washer
Chart 1: Thread friction T and Washer friction W (according to DIN946)
8.8 10.9 12.9 A4
0.15 -
0.17 -
0.12 0.14 0.14 -
0.14 0.11 0.11 -
0.11 0.14 0.15 0.14
0.12 0.10 0.10 0.15
Chart 2: Yield points for most common bolt grades
Bolt grade Yield point [Mpa] 3.6 180 4.6 240 4.8 320 5.6 300 Steel 5.8 400 6.8 480 8.8 640 9.8 720
Ratio of Tension yield point [%] [Mpa] H 0
Clamp load [kN]
Tightening torque [Nm]
0.0
0.0
10.9 900
12.9 1080
A4-50 210
