Scribd
Upload
20 views1 page

PDF 5

Uploaded by

pallavihivvrale3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views1 page

PDF 5

Uploaded by

pallavihivvrale3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

side, it performs demodulation, convert analog signal (electrical signal) into binary form PAG

(10011011000011). At sender side, it performs modulation and converts digital signal


into analog signal, just opposite of demodulation.

What is a repeater?
Repeater is a layer 1 device. Repeater is used to reproduce the original strength of the
signal. For example, when a signal travels a long distance, signal
strength fades away. In that situation we need a repeater in the midway to recover the
original signal strength.

Hub

Hub

Hub
8/144
Switch

www.nwkings.com

What is Access point(AP)? wired one. I


networks, our LAN network is
In traditional connected together through wired
mean alldevices are
scenario is
connection. But, now the wired
have both type of hosts
different, LAN networks wireless devices to
host. To connect
host and wireless
access points.
wired network, we use are used to
can say access points network to
In other words, we into existing wired
merge wireless network Sometimes APs
proper utilisation of resources. range-extender).
achieve range (works as
the signal
are used to extend
points.
What is WLC? manage the Access
link controller. It is used to
WLC stands for wireless

commands for CCNA!


Some Cmd
internet gopher
1. ping :- packet
ICMP protocol ?? PAG
to me or not
it works on device is reachble
the other
For verification
a computer
;- to check the ip address of + mac address
2. ipconfig the ip address computer
/all :- to check address ofa
3. ipconfig mac
4. getmac:- to check the session's
to check the of a website
5. netstat :- the all servers
nslookup :- to check
6. table administrator)
to check arp
7. arp-a :- delete arp table ( run as
to
8. arp -d :- your public ip
public ip
www.whatismyipaddress.com to check
9. To check CARLE MOy

Visit :- cHC)
NTERNET

WLCL

AP1 24

une
WATNE nnn a'34

t62.164.S

www.nwkings.com

You might also like