Alternating Current Level-2

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

ALTERNATING CURRENT

Total Marks: 100 Time: 60 Minutes

Physics Section A

Q.1

A) B) C) D)

Q.2

A)

B)

C)

D)
Q.3

A) B) C) D)

Q.4

A) B) C) D)
Q.5

A) B)

C) D)

Q.6

A)
B)
C)
D)
Q.7

A) B) C) D)
Q.8

A) B)
C) D)
Q.9

A) B) C) D)
Q.10

A) B) C) D)
Q.11

A) B)

C) D)

Q.12

A) B) C) D)
Q.13 In an LC oscillator, if values of inductance and capacitance become twice and eight times,
respectively, then the resonant frequency of oscillator becomes x times the initial resonant frequency
of ω0. The value of x is
1 1
A) B) 4 C) 16 D)
4 16
Q.14 In the given circuit, rms value of current (Irms) through the resistor R is:

1
A) A B) 20 A C) 2 A D) 2 2 A
2
Q.15 An alternating voltage source V = 260sin(628t) is connected across a pure inductor of 5 mH. Inductive
reactance in the circuit is:
A) 3.14 Ω B) 6.28 Ω C) 0.318 Ω D) 0.5 Ω
Q.16 For the given figures, choose the correct options:

A) The rms current in circuit (b) can never be larger than that in (a).
B) The rms current in circuit (b) can be larger than that in (a).
C) The rms current in figure (a) is always equal to that in figure (b).
D) At resonance, current in (b) is less than that in (a).
Q.17 A capacitor of capacitance 150.0 μF is connected to an alternating source of emf given by
E = 36sin(120π t) . The maximum value of current in the circuit is approximately equal to:
1
A) A B) 2A C) 2 A D) 2 2 A
2
Q.18 Primary side of a transformer is connected to 230 V, 50 Hz supply. Turns ratio of primary to secondary
winding is 10 : 1. Load resistance connected to secondary side is 46 Ω. The power consumed in it is
A) 10.0 W B) 12.0 W C) 11.5 W D) 12.5 W
Q.19 In an a.c. circuit voltage and current are given by :
V = 100 sin (100 t) V and
⎛ π ⎞
I = 100 sin ⎜⎜100t + ⎟⎟ mA respectively.
⎝ 3⎠
The average power dissipated in one cycle is :
A) 25 W B) 2.5 W C) 10 W D) 5 W
Q.20 Primary coil of a transformer is connected to 220 V ac. Primary and secondary turns of the transforms
are 100 and 10 respectively. Secondary coil of transformer is connected to two series resistances
shown in figure. The output voltage (V0) is:

A) 15 V B) 22 V C) 44 V D) 7 V
Q.21 A transformer has an efficiency of 80% and works at 10 V and 4 kW. If the secondary voltage is 240 V ,
then the current in the secondary coil is :
A) 1.59 A B) 15.1 A C) 13.33 A D) 1.33 A
Q.22 An alternating volage V (t) = 220sin100 π t volt is applied to a purely resistive load of 50Ω . The time
taken for the current to rise from half of the peak value to the peak value is :
A) 3.3 ms B) 2.2 ms C) 5 ms D) 7.2 ms
Q.23 Match List-I with List-II
List-I List-II

(A) Purely capacitive circuit (I)

(B) Purely inductive circuit (II)

(C) LCR series at resonance (III)

(D) LCR series circuit (IV)

Choose the correct answer from the options given below :


A) A-I, B-IV, C-III, D-II
B) A-IV, B-I, C-III, D-II
C) A-IV, B-I, C-II, D-III
D) A-I, B-IV, C-II, D-III
Q.24 Given below are two statements :
Statement I : In an LCR series circuit, current is maximum at resonance.
Statement II : Current in a purely resistive circuit can never be less than that in a series LCR circuit
when connected to same voltage source.
In the light of the above statements, choose the correct from the options given below :
A) Statement I is true but Statement II is false
B) Statement I is false but Statement II is true
C) Both Statement I and Statement II are true
D) Both Statement I and Statement II are false
Q.25 A LCR circuit is at resonance for a capacitor C, inductance L and resistance R. Now the value of
resistance is halved keeping all other parameters same. The current amplitude at resonance will be
now:
A) Zero B) double C) same D) halved

You might also like