International Journal of Gender, Science and Technology UGC Care Group I Journal

..ISSN: 2040-0748 Vol-13 Issue-02 June 2024

Advanced wireless power transfer system using Arduino

Mr.G.Sai Ram[1], Assistant Professor[1]

Siddhartha Institute of Engineering and Technology[1], Ibrahimpatnam

Abstract potential replacement for conventional cable

charging methods is WPT (wireless power
The charging of electric vehicles (EVs) could
transfer) technology, which does away with
undergo a dramatic shift with the advent of
the requirement for physical links
WPT (wireless power transfer) technology.
There are a number of advantages to
among the infrastructure for charging and the
integrating WPT with the grid and renewable
electric vehicle. The use of WPT in
energy sources like solar power, including
conjunction with the grid and renewable
less pollution, cheaper energy, and more
energy sources like solar power has several
reliable electricity. Wireless power
benefits, such as lowering energy prices,
transmission for electric car charging
increasing grid stability, and reducing carbon
utilizing sun or grid energy is discussed in
footprint. Their liability and power
this abstract, which offers a review of the
availability might be improved with this
several factors involved. After a brief
combinational system, which also offers
overview of WPT and its background, the
advantages for peak shaving and load control.
various WPT technologies for pv and grid
Using solar and grid electricity, this study
integration are detailed. Later on, it describes
outlines the many facets of wireless power
how to optimize distance, alignment, and
transmission for charging electric
frequency—three aspects that impact WPT
automobiles. The article starts off by
efficiency—for grid and solar integration.
providing a concise overview of WPT
Introduction technology's background and outlining the
various WPT options for solar or grid
More efficient and environmentally friendly
integration. Next, it delves into the specifics
charging options are in high demand due to
of optimizing WPT for solar or grid
the rising popularity of electric cars (EVs). A
integration by looking at variables like
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
frequency, distance, and alignment, all of solar and grid electricity. Transferring
which impact efficiency. Solar power for electrical energy from a generator to a
WPT has several advantages, such as less consumer or the power grid without the need
carbon emissions, cheaper energy, and more of individual man-made wires is known as
stable grid operation, but there are also some wireless electricity transfer (WPT), electrical
disadvantages to solar integration, such as energy delivery, or electromagnetic power
solar power's unpredictability and the transfer. A wide variety of power
necessity of energy storage solutions. transmission systems that make use of
Enhanced power availability and reliability, electrical power, magnetized, or
as well as the possibility of load control and electromagnetic fields that fluctuate with
peak shaving, are some of the advantages of time are together known as wireless power.
grid integration that are covered in the article. With wireless energy transfer, a power
source's electromagnetic field is sent via an
intervening distance to one or more the
recipients which subsequently transform it
into an electrical current for usage. When
connecting cables is not an option, is too
dangerous, or just not feasible, wireless
transmission can power electrical equipment.
Radiative and non-radiative wireless power
methods are the two basic types. Power is
transmitted in short field or non-radiative
Finally, the article wraps up with a review of
methods by use of electric fields susing
where WPT is in terms of solar and grid
capacitive connections between metal
energy EV charging, including topics such as
electrodes or magnetic fields used in
laws and standards development, commercial
inductive coupling between wire coils. Of all
accessibility of WPT recharging systems, and
the wireless technologies, inductive coupling
the technology's potential moving forward.
is by far the most common and ubiquitous. It
The overall environmental impact and
powers and charges electric trains, buses, and
effectiveness of electric vehicle charging
implant table surgical instruments like
might be greatly enhanced by combining
artificial cardiac pacemakers, as well as
WPT is an and sources of clean energy like
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
RFID tags, smart cards, and electric tooth well the simulated results performed under
brush chargers. Presently, research is focused different environmental conditions (sunlight,
on creating wireless systems that can power temperature, and wind speed). Discussion
portable electronics like laptops, digital and analysis of the findings follow. When
music players, and smartphones without deciding whether or not to employ a hybrid
connecting them to a wall outlet. structure instead of two individual devices, a
Power beaming, another name for far-field or validated model might be helpful.
radioactive methods, involves the Block Diagram
transmission of energy by electromagnetic
radiation beams such as lasers or
microwaves. However, these methods need
precise targeting of the receiver in order to
transmit energy across greater distances.
Some possible uses for this category include
solar-powered satellites and drones that are
powered by wireless technology.

Related Work

Mobiles powered by solar energy were

developed. A state-of-the-art wireless
charger was recently put into use, especially
for systems with tiny loads. A commercial
panel, temperature and electrical wiring, and
a state-of-the-art wireless remote data
collecting system make up the whole system's
prototype. The latter has the essential
Proposed System
properties of precision, remote data
collecting, and flexibility, and it is built A high-frequency wireless transmitting coil,
around an open-source electronic platform. an inverter, and a rectifier make up the
After the model was fine-tuned, it was transmitter block of this system. The solar
contrasted with experimental data to see how panel provides the electricity. The energy is
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
sent to the rectifier circuit from a battery that businesses rely on photovoltaic modules,
stores it, as well as from the grid. The rectifier which together make up the array. Typically,
circuit corrects the power and sends it on to modules are rated from 100 to 365 watts
the high-frequency transmission coil. To based on their DC power output under typical
change the transmission power, the test conditions (STC). For the same rated
microcontroller in the transmitter circuit is output, the size of a module is determined by
linked to the inverter circuit. Switching the its efficiency; for example, a 230 watt module
power has improved the transmission power with an efficiency of 8% would have double
efficiency. The inverter circuit receives the area of a 230 watt module with an
switching power from the driving circuit. efficiency of 16%. It has been stated that
One component of the receiver block that there are a handful of solar modules on the
takes electricity from the transmitter is the market with efficiencies higher than
receiving coil. After that, the electricity goes 24%.Most solar power setups use many
into the battery and regulator circuits via the modules since a single module has a limited
rectifier circuit. The temperature sensor power output. A photovoltaic system usually
keeps track of the battery's level. A buzzer consists of a number of components,
will go out if the temperature readings go too including a solar tracking device,
high. The controller receives the controlled interconnecting cable, a set of batteries for
power in order to operate the vehicle's motor. storage, an array of solar panels, and an
The charging state is shown via the LED, and inverter. Water heating systems that use solar
details on the transfer of energy and charging panels are the most prevalent. As a result of
may be seen on the LCD. The controller ongoing price drops, solar power is now
controls the 12 volt motor via the motor drier. competitive with grid-supplied energy from
Each motor's rotation may also be controlled. fossil fuels in many nations. Stylish and
One definition of a solar panel is an electrical durable 3W 12V DC photovoltaic solar
or thermal energy collector that uses the rays panel. Protected against wind, snow, and hail.
of the sun as an input. Usually, 6×10 Solar cells made of multi-crystalline silicon
photovoltaic solar cells are assembled into a housed in a sturdy iodized aluminum
photovoltaic (PV) module. Commercial and housing. Low-iron tempered glass with a
residential photovoltaic systems that harness high level of transparency.measuring 188 by
the sun's energy to power homes and
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
195 by 17 millimeters. Connector housing for
use with solder or screw terminals.

Results

Conclusion

Views on electric car wireless charging were

offered in this study. For the purpose of
charging electric vehicles, we provide a
wireless power transmission technology that
is both efficient and effective. We delved
deep into the analysis and discussion of
system setup and design factors.
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
Environmental and energy-related concerns Electronics (WZEE), 2015, Kielce, 2015,
make the electrification of vehicles an pp.1-6.
inevitability. There are a lot of advantages to
[3] J. H. Kim et al., "Development of 1-MW
wireless charging over cable charging. A
Inductive Power Transfer System for a
possible solution to the problems with wired
HighSpeed Train, "in IEEE Transactions on
chargers and other roadblocks to sustainable
Industrial Electronics, vol. 62,no.10,pp.6242-
mobility and vehicle electrification is WPT
6250,Oct. 2015
for EVs. In addition to being more convenient
than cable chargers, WPT also allows for a [4] R. Haldi and K. Schenk, "A 3.5 kW
considerable reduction in the size of the Wireless Charger for Electric Vehicles with
electric vehicle's onboard battery. Solar Ultra High Efficiency," Energy Conversion
energy, one of the most well-known Congress and
renewable power sources, was used to design, Exposition(ECCE),2014IEEE,Pittsburgh,PA
construct, and test a prototype. The eventual ,2014,pp.668-674.
realization of wireless EV charging is within
[5] C. Y. Liou, C. J. Kuo, and S. G. Mao,
reach, thanks to technological advancements.
“Wireless-power-transfer system using near-
Upcoming research is still lacking in the
field capacitively coupled resonators,” IEEE
areas of structure, control, inverters design,
Transactions on Circuits and Systems II:
and human safety.
Express Briefs, Vol. 63, Issue: 9, Sept. 2016,
References pp.898-902.

[1] F.Musaviand W.Eberle,"Overview of [6] C. S. Wang, O. H. Stielau and Covic, G.

Wireless Power Transfer Technologies for A, "Design considerations for a contactless
Electric Vehicle Battery Charging, "in IET electric vehicle battery charger,"IEEE
Power Electronics, vol. 7,no.1,pp.60- Transactions on Industrial
66,January 2014. Electronics,vol.52,no.5,pp.1308-
1314,Oct.2005.
[2] M.P.Kazmierkowski,
R.M.Miskiewiczand A.J.Moradewicz, [7]
"Inductive coupled contactless energy C.L.Yang,Y.L.Yang,andC.C.Lo,“Subnano
transfer systems-are view, "Selected second Pulse Generators for Impulsive
Problems of Electrical Engineering and Wireless Power Transmission and Reception,
 International Journal of Gender, Science and Technology UGC Care Group I Journal
..ISSN: 2040-0748 Vol-13 Issue-02 June 2024
”IEEE Transactions on Circuits and Systems
II: Express Briefs, 2011, Vol.58,Issue:
12,pp.817-821.

[8] C. S. Wang, G. A. Covic, and O. H.

Stielau, “Power transfer capability and
bifurcation phenomena of loosely coupled
inductive power transfer systems,” IEEE
Transactions on Industrial Electronics, vol.
51, no. 1, pp.148-157,Feb.2004.

[9] Fariborz Musavi and Wilson Eberle,

“Overview of wireless power transfer
technologies for electric vehicle battery
charging,” IET PowerElectronics,Volume7,
Issue1, 2014,p.60 – 66.